Full automatic punching machine It is a kind of mechanical equipment used for punching on metal plates.
In order to ensure the normal operation and safety of the equipment, appearance inspection is required.
The following are all Auto punching machine Visual inspection steps:
1、 Check the cleanliness of the machine tool surface.
The whole machine tool surface shall be clean, free of oil spots, stains, and bright without scratches.
2、 Check all parts of the machine
For example, the handle, dial, button, gate, foot switch and brake can maintain the design performance, and no loosening, jamming, difficult operation, etc. are allowed.
3、 Check whether the lubricating oil at all parts of the machine tool is sufficient.
It is required that the oil at each lubrication point is sufficient, the lubrication system works normally, and there is no oil leakage.
4、 Check the normal operation of the electrical part of the machine tool.
The switchgear is required to be well sealed, and the leads of all electrical components are fixed reliably without looseness.
The switches of electrical equipment work normally, and the cables and electrical wires are concealed without breakage, aging, twists and turns.
5、 Check the reliability of the press.
It is required to check whether each punch bit is placed in order and whether the wear of shaft and connecting rod is normal,
Check whether the stamping action is smooth, free of looseness, stagnation, idle abnormal noise and other abnormal conditions.
6、 Tighten all fasteners.
Check all fasteners one by one to avoid looseness and ensure safe and reliable use of the machine tool.
7、 Check the integrity of each protective device.
All safety protection devices are required to be complete, intact, in correct position and with good functions to effectively ensure personnel safety.
The above is fully automatic Punching machine Through careful and careful inspection, we can prevent machine tool failures and accidents and effectively ensure equipment operation efficiency and personnel safety.
