During commissioning, it is not necessary to feed materials, but it is necessary to first raise the guide screw on the guide plate, and then gradually adjust the ram of the punch to the bottom dead center by inching. It is necessary to pay special attention to that the guide plate should not press the floating rod too low, otherwise the floating rod will be bent or broken.

When starting the punching machine for continuous punching, it is necessary to rotate the speed adjusting screw of the nc servo feeder clockwise. The slider moves slightly slowly, so that it can be seen whether the slider touches the nylon gasket and the length adjusting screw when it moves back and forth.

If the sliding block moves back and forth, Full automatic punching machine Only the length adjusting screw is touched, but the nylon gasket is not touched. This is because the floating rod is lowered too deep, and the guide screw on the punch needs to be gradually raised.

All Auto punching machine During the test run, the sliding block moves back and forth, and the stainless steel pipe Guardrail punching machine If you only touch the nylon gasket but not the length adjusting screw, the floating rod will not be lowered deeply. You need to gradually adjust the guide screw on the punch down.