1、 It is not necessary to lower the head to check the actual operation of punching

application Full automatic punching machine The application steps must be strictly followed.

In particular, do not lower your head to check the actual operation of punching.

In the whole process of punching, the ordinary raw material grinding workpiece must be made into a special-shaped workpiece with exquisite appearance design,

As a result, more raw material chips will be produced. During the whole process of punching, it is very easy to eject with high pressure steam,

In order to better ensure safety, it is forbidden to check the condition of stamping dies in violation of regulations.

2、 It is not necessary to operate the equipment when the die is stuck

Because when punching, there will be a lot of waste of raw materials left Punching machine And then into the lower die hole.

If it is not cleaned immediately, it may be blocked. When the lower die hole is blocked, be sure not to operate the equipment,

Avoid unstable operation of equipment or weaken its service life.

3、 Pay attention not to be excessively convex and concave when being washed out

In order to better ensure the quality of the workpiece and the precision of its accurate positioning,

Therefore, when using the automatic punching machine, pay attention to check whether the punching line is excessively convex or concave,

During the work, it should be kept basically flat. Query whether there are objects endangering its stability.

4、 It is not necessary to remove and replace the mold shell when loading

Different workpieces have different hole diameters, and at the same time, the relativity of connectors will change,

However, pay attention to the application of automatic punching machine. When it is still loaded, it is not necessary to remove the connector to prevent damage to the equipment.