Angle steel punching machine It is a kind of equipment widely used in construction engineering, metal manufacturing, machinery manufacturing and other fields.

As mechanical equipment, angle steel Punching machine Various problems may be encountered during the use, such as sudden shutdown, which affects the normal use of the equipment.

Then, why did the punching machine for angle steel stop suddenly?

This article will analyze the possible causes from the general situation of the angle steel punching machine, electrical problems, air supply problems, mechanical structure problems, and provide corresponding solutions.

1、 General situation of angle punching machine

Angle steel punching machine is usually composed of electrical, pneumatic, mechanical and other parts.

In the process of use, if a sudden shutdown occurs, first check whether it is the fault of the equipment itself.

In order to avoid similar problems, the following points should be paid attention to when using the angle steel punching machine:

1. Before use, carefully check whether the mechanical and electrical connections of each component are firm.

2. Avoid excessive use of angle steel punching machine to avoid excessive mechanical load, thus reducing the service life of the machine.

3. Regularly maintain the angle steel punching machine, such as cleaning the air path, circuit, drill bit, mold and other parts.

4. Use effective safety protection measures to protect the safety of operators.

2、 Electrical problems

The electrical system of the angle punching machine is an important part of its normal operation.

In the process of use, if there are electrical problems, such as power failure, short circuit, lack of equality, it may lead to sudden shutdown of the angle punching machine.

1. Equipment power supply problem:

Such as circuit breaker tripping, fuse fusing, power line loosening and other problems.

Solution: Check the power supply and plug connection, find out the problem and replace the damaged parts.

2. Control circuit fault:

For example, controller failure, switch button failure, etc.

Solution: Check the connection of the controller, switch button and other parts, find out the problem and replace the damaged components.

3. Lack of power supply:

For example, the power supply at the construction site is unstable, or the machine is connected to the wrong circuit breaker.

Solution: Check whether the power supply voltage meets the requirements of the machine. It is recommended to use stable power supply or auxiliary equipment such as voltage regulator.

3、 Air source problem

The angle punching machine uses air as the power source, and the air source problem will also lead to its sudden shutdown.

1. Insufficient air pressure:

For example, the problem of air supply at the construction site.

Solution: Check whether the air source pressure meets the equipment requirements. If the pressure is insufficient, increase the air source pressure.

2. Valve abnormality:

For example, the filter screen of the speed control valve is blocked, and the air pipe is connected above the exhaust pipe.

Solution: Clean the filter screen, thoroughly remove the waste gas pipe and other problems, and ensure that the air source is unblocked.

4、 Mechanical structure problems:

Mechanical structure problems may also lead to sudden shutdown of the angle punching machine;

1. Linear guide rail and bearing are not cleaned:

Impurities and dust lead to inflexibility of parts.

Solution: Clean the linear guide rail and bearing regularly to ensure the flexibility of parts.

2. Insufficient punching fluid:

Lack of necessary protection and proper lubrication during operation will cause sudden shutdown of angle steel punching machine.

Solution: Check the lubricating oil regularly and add it in time.

In a word, the angle punching machine stops suddenly due to various reasons, so we must pay attention to finding problems and solving them in time during the use. The solution is to avoid problems, and to ensure the normal operation of the machine by taking measures such as regular maintenance and servicing of equipment, and paying attention to staff safety. In addition, if you encounter problems that cannot be solved, you can seek help from professional manufacturers.