When Angle steel punching machine After disassembly, it can be cleaned with cleaning solution.

Common cleaning solutions include organic solvents, alkaline solutions and chemical cleaning solutions. The cleaning methods include manual and mechanical cleaning.

Next, the small editor will specifically introduce the cleaning of angle steel Punching machine What are the cleaning agents for.

1. Organic solvents:

Common ones are kerosene, light diesel, gasoline, alcohol and trichloroethylene.

Organic solvent degreasing is based on the dissolution of dirt. It has no damage to metal, can dissolve all kinds of grease, does not need heating, is simple to use, and has good cleaning effect.

However, most of the organic solvents are flammable, with high cost. They are mainly suitable for small-scale units and scattered maintenance work;

2. Alkaline solution:

It is an aqueous solution of alkali or alkaline salt.

Use alkaline solution and saponifiable oil on the surface of parts to initiate chemical reaction,

Produce soap that is easy to dissolve in water and glycerin that is not easy to float on the surface of parts, and then wash with hot water to remove oil easily.

If unsaponifiable oil and saponifiable oil are not easy to remove, emulsifier shall be added to the cleaning solution to separate the emulsified oil stain from the part surface.

Common emulsifiers include soap, water glass (sodium silicate), bone glue, gum, etc. Different cleaning solutions shall be used to clean parts with different materials.

Alkaline solution can corrode metals to varying degrees, especially aluminum;

3. Chemical cleaning solution:

This is a chemically synthesized water metal detergent, mainly surfactant,

Because its surfactant reduces the interfacial tension, it has many functions, such as wetting, osmosis, emulsification, dispersion, etc., and has a strong decontamination ability.

It is also non-toxic, non corrosive, non combustible, non explosive and pollution-free,

It has the advantages of certain antirust ability and low cost, and has gradually replaced other cleaning fluids.

In order to give better play to the performance of the angle punching machine, what matters should be paid attention to when using the angle punching machine and when maintaining it later?

Here is a brief introduction to the relevant content.

The oil of the angle punching machine needs to be replaced regularly, basically every year,

For the first time, the replacement time should be less than 3 months, that is to say, it should be replaced within 3 months.

In order to ensure the flexibility of the machine, its sliding block also needs to be lubricated frequently,

Generally, the machine needs to be injected with oil before running, and the column surface of the machine needs to be clean.

The appearance of the angle punching machine saves manpower, NC positioning, saves the time of die changing, improves production efficiency, and improves the safety factor.

In short, special attention should be paid to the daily use of the angle steel punching machine, and regular inspection and maintenance should be carried out to ensure the normal operation of the machine.