As an industrial equipment, Zinc steel guardrail punching machine During use, attention should be paid to maintenance at any time to ensure the normal operation and service life of the equipment.

The following is zinc steel Guardrail punching machine Detailed description of maintenance precautions:

1、 Routine maintenance

1. Pay attention to the cleanliness of the equipment, timely clean the dust and oil around the equipment, and ensure that the equipment is clean and tidy.

2. Regularly check the fasteners and transmission parts of each part of the equipment to ensure that they are reliably fixed and operate normally.

3. Regularly check whether the wires and power plugs of the equipment are worn, and replace them if necessary.

4. Regularly check whether the lubricating oil of the equipment is sufficient and clean, and replace and add it if necessary.

5. Regularly check whether the electrical circuit and electrical components of the equipment work normally, and repair or replace them if necessary.

6. The equipment shall be debugged on a regular basis, and when it is required to be used in combination, the equipment shall be adjusted to a proper position and the working parameters shall be accurate.

2、 Common faults and solutions

1. Machine does not start

(1) Possible causes: ① Power line fault; ② The power switch is faulty.

(2) Solution: Check the power circuit and power switch, and replace or repair the circuit or switch if necessary.

2. Poor punching and uneven holes

(1) Possible causes: ① The punch is worn or damaged; ② The distance between the punch and the upper and lower templates is incorrect.

(2) Solution: ① Replace or repair the punch; ② Adjust the distance between the punch and the upper and lower templates.

3、 Punching machine Excessive vibration or noise

(1) Possible causes: ① The equipment foundation is not firm; ② The whole set of equipment is damaged and severely aged.

(2) Solution: ① Equipment foundation strengthening; ② Replace or repair the equipment for overall maintenance.

3、 Maintenance precautions

1. The zinc steel fence punching machine needs to be packaged when not in use and placed in a dry and ventilated place to avoid direct sunlight, wind and rain.

2. After the punching machine has been used for a period of time, it needs to carry out comprehensive inspection and maintenance of the machine, grind the punch and lubricate the transmission chain.

3. In case of sudden power failure or emergency of the machine, the machine shall be shut down and stopped in time to avoid other problems.

4. When the zinc steel fence punching machine is in operation, it is necessary to select a suitable punch for hole drilling according to different parts types.

5. Do not pinch or interfere in the equipment during the operation of the machine. If other operations or maintenance need to be completed, they should be completed under the premise of shutting down the machine.

In a word, the maintenance of the zinc steel fence punching machine is very important. Only by strictly following the maintenance procedures can the normal operation of the equipment be ensured, the service life of the equipment be extended, and the work efficiency and safety be improved.