Piercing machine for stair handrail How to work safely?

Stair handrail Punching machine After a long time of work, attention should be paid to maintenance, so as to increase the service life of the stair handrail punching machine and bring greater work efficiency.

Maintenance content and method of stair handrail punching machine: the upper and lower dies of stair handrail punching machine must not be installed reversely, otherwise the use of the whole machine will be adversely affected.

Attention should be paid to the waste materials generated during the hole cleaning to avoid damage to the machine and tools due to the filling of the lower die hole. When assembling the upper and lower moulds for the stair handrail punching machine, the models of the upper and lower moulds must be the same, and the fixing sleeve of the upper mould must be tightened. It is not allowed to work or store in the place with corrosive substances. Do not remove the quick coupling under load. When placing the lower die of the stair handrail punching machine, pay attention to the upward cutting edge (the end with a small hole diameter), and do not install it to damage the machine. During the operation of the stair handrail punching machine, when the system has working pressure, do not remove the quick connector. Pay attention to refueling and bleeding after use. The system pressure of the electric pump matched with the stair handrail punching machine has been calibrated to be within the range of 63MPa before leaving the factory, and users cannot adjust it at will. The washed discharge shall be basically flat.

Only by strictly paying attention to the use of stair handrail punching machine before and during work can the production efficiency be improved and the service life be extended.