First observe CNC punching machine The chassis shall be leveled and stabilized after the punching equipment is in place, Punching machine The frame shall be vertical, and the grounding protection shall be done according to the construction power requirements.

Secondly, before starting work, carefully check whether each component is properly configured and whether the fastening part is loose and falling off. If there is any abnormality, timely and correctly handle it.

        Zinc steel guardrail punching machine Usually, there are many kinds of protective devices. Before starting operation, make sure that these protective devices can work normally, which can improve the safety protection performance of the NC punching machine during operation and effectively reduce the accident rate during operation.

In addition, the operator shall wear all kinds of armor as required, clean up the sundries on the machine table and within a certain range around, and irrelevant personnel shall not be close to the working area when the punching machine is running.

In order to improve the safety of operation, Rack punching machine Operators shall not only strictly abide by their posts, but also place all tools and accessories on the NC punching machine at the specified positions, so as to avoid accidents caused by the impact on the equipment during the operation of the punching machine.

If everyone can follow the regulations when operating the NC punching machine, and do a good job in the relevant inspection work, and at the same time improve the safety awareness, then the operation safety of the NC punching machine can be effectively improved, which can not only make employees feel safer when working, but also improve the efficiency of production and processing, And save the cost of handling accidents for enterprises.