During commissioning, it is not necessary to feed materials, but it is necessary to first raise the guide screw on the guide plate, and then gradually adjust the ram of the punch to the bottom dead center by inching. It is necessary to pay special attention to that the guide plate should not press the floating rod too low, otherwise the floating rod will be bent or broken. purchase Numerical control punching machine for zinc steel guardrail Which one is good When starting the punching machine for continuous punching, it is necessary to rotate the speed adjusting screw of the nc servo feeder clockwise. The slider moves slightly slowly, so that it can be seen whether the slider touches the nylon gasket and the length adjusting screw when it moves back and forth. Numerical control punching machine for zinc steel guardrail If the full-automatic punching machine only touches the length adjusting screw but not the nylon gasket when the sliding block moves back and forth, it is because the floating rod is lowered too deep, and the guide screw on the punching machine needs to be gradually raised.

If the round pipe punching machine used by the enterprise has the specified special hydraulic oil, the special hydraulic oil should be used according to the requirements instead of mixing with other types of hydraulic oil. Shijiazhuang purchase Numerical control punching machine for zinc steel guardrail If the round pipe punching machine does not have the specified hydraulic oil, the appropriate hydraulic oil brand can be selected according to the working environment and working conditions of the hydraulic system. After selecting the type of hydraulic oil, the enterprise must also determine the viscosity of the hydraulic oil required by the pipe punching machine. Numerical control punching machine for zinc steel guardrail The viscosity should be selected according to the temperature range of the geographical location. Generally speaking, the thinner hydraulic oil can be used in the northern region, and the hydraulic oil with a slightly higher viscosity can be used in the southern region. Because the temperature in the north is low, if the viscosity of the hydraulic oil is high, it is not conducive to the operation of the hydraulic system in the low temperature environment.

The normal CNC punching machine can customize the operation procedure of the product according to the customer's product requirements, Shijiazhuang Numerical control punching machine for zinc steel guardrail And the whole process does not require professional computer personnel to program. The CNC punching machine has specially designed a humanized human-computer interactive operation screen. The operator only needs to input the required punching hole diameter, punching hole position, thickness and other variables, and then just wait and observe whether the equipment is in good condition. The CNC punching machine adopts the domestic double vane pump as the main component equipment of its bearings, purchase Numerical control punching machine for zinc steel guardrail Compared with the traditional pump, this equipment has the characteristics of low noise, high efficiency, large flow and long service life. At the same time, the high-quality CNC punching machine is specially equipped with a high-quality cooling system to ensure the smooth and efficient operation of the equipment.

For CNC punching machine equipment, quality is the hard truth for enterprises to survive. Therefore, we must ensure the stability of product quality. Equipment and materials of CNC punching machine; Due to the increased cost of current materials, Shijiazhuang Numerical control punching machine for zinc steel guardrail Which one is good Some enterprises will start with raw materials and choose inferior materials to replace them. The result is that the product quality is not guaranteed. Before using the automatic CNC punching machine, be sure to check whether there are sundries at the punch and the lower die edge. Add lubricating oil to the upper and lower moving parts of the punch. Numerical control punching machine for zinc steel guardrail During use, keep the oiling part of the numerical control punching machine free of oil shortage. At the same time, it should be noted that after the use of the NC punching machine is completed, the NC punching machine should be cleaned first, and the punch should be pressed down to the low position to better protect the NC punching machine.