Full automatic punching machine The solutions for insufficient pressure in use are as follows:

1. If this happens to the new machine, first confirm whether the hydraulic oil is added according to the oil quantity recommended by the manufacturer. If it is not enough, add hydraulic oil again.

2. After disassembling the mold, ensure that the mold is not damaged when checking the problem.

3. Check whether the die punching pin is worn. If necessary, buy a new one from the manufacturer.

4. Check whether the solenoid valve is stuck.

5. Enlarge Punching machine The pressure of each manufacturer is different, which needs to be confirmed with the manufacturer.

6. Check or replace the seal or hydraulic oil pump.

7. Enterprise in the whole Auto punching machine Employees should also carefully check the equipment parts exposed to the air.

8. Once any abnormality is found, stop the operation immediately, and then restart the job after troubleshooting.

9. This can effectively protect the equipment from damage, extend the service life and provide better services for enterprises.

10. Mechanical equipment needs regular maintenance to be used more smoothly and for a longer time,

11. The full-automatic punching machine should also be well maintained during use to extend its service life!