in use Full automatic punching machine When cutting, one of the common problems is cutting materials, which affects the cutting effect and work efficiency.

This kind of problem usually occurs Auto punching machine The air pressure of is not adjusted properly.

fully automatic Punching machine In the process of laser cutting, the pressure of auxiliary gas has a great influence on the cutting results.

The auxiliary gas shall have enough pressure to remove the waste slag generated by cutting in time,

Generally, when cutting a thicker workpiece, the air pressure should be reduced a little. The residue stuck to the workpiece will damage the cutting edge and also affect the cutting accuracy!

When we use the full-automatic punching machine to cut, if we want to cut the cut products well to achieve cutting, we must first understand which aspects will affect the cutting accuracy.

Here's a brief introduction:

1. Laser beam quality:

The light beam emitted by the laser is conical, so the slit cut is also conical,

In this case, the 0.4MM thick stainless steel will be much smaller than the 3MM slit.

Therefore, the shape of the laser beam depends on a major factor that affects the cutting accuracy of the metal laser cutting machine.

Under the condition of this tapered laser beam, the greater the thickness of the workpiece, the lower the accuracy will be, so the larger the kerf.

2. Accuracy of the worktable of the full-automatic punching machine:

If the accuracy of the workbench is uneven or other reasons can also lead to high-precision laser cutting effect.

When the tapered laser beams are gathered together, they will become smaller and smaller,

Therefore, the precision of laser cutting is becoming higher and higher, In particular, the width of the slit becomes smaller and smaller.

At this time, the light spot can reach 0.01mm.

This is also one of the factors that affect the cutting accuracy and cutting continuity of the laser cutting machine.

3. Material of cutting workpiece:

In practical application, the cutting accuracy of different materials is slightly different.

Even for the same material, if the composition of the material is different, the cutting accuracy will also be different.

Therefore, the workpiece material has a certain impact on the laser cutting accuracy.

The laser with different laser power shall be selected for workpieces made of different materials, which is also one of the ways to avoid the continuous cutting of workpieces by the automatic punching machine.

The above is the reason why the full-automatic punching machine cannot cut materials. When using the full-automatic punching machine to cut workpieces, you should adjust the cutting parameters of the full-automatic punching machine according to the actual situation of the cutting workpieces, so as to avoid the full-automatic punching machine cutting workpieces, affecting the cutting effect and work efficiency!