With the arrival of the automation era, NC thick wall pipe punching machine It is used more and more widely, but Punching machine In the process, the first thing we should pay attention to is safe production and use Stainless steel punching machine On the site, the hole location and surrounding stones and other obstacles shall be removed according to the requirements of the punching machine instructions. The distance from the operation site to the power transformer or power supply trunk line shall be within 200m, and the voltage drop during startup shall not exceed 10% of the rated voltage.

The motor and control box shall have good grounding device. Before installation, check and confirm that the punch bar and all parts are free of deformation; After installation, the allowable deviation of the center line between the punch and the power head is 1% of the total length. When installing the punch, start from the power head and install it section by section. It is not allowed to lift and install the punch rod after all the required lengths are connected on the ground. Before installing the power head, the pulley block shall be removed and the wire rope shall be wound. The steel wire rope shall be selected according to the requirements specified in the instruction manual.

After installation, the frequency of the power supply shall be the same as the pointer on the frequency change-over switch in the control box. If it is different, the frequency change-over switch shall be used for conversion. numerical control Climbing frame punching machine It should be placed stably and firmly. The truck type punching machine should set up the outrigger, support the tire, and use automatic fine adjustment or wire hammer to adjust the tappet to keep it vertical.