• Product (1)
• News (6)

Current label: Automatic punching machine equipment

• What are the precautions in the operating procedures of the automatic punching machine?

  2020-03-04
  Observe the "Motor" safety operation regulations. After the punching (drilling) machine is in place, the chassis shall be leveled and stabilized, and the punching frame shall be vertical. The punching (drilling) machine shall be grounded and protected according to the requirements of temporary power supply for construction. Before spudding, carefully check whether the drill cone, hammer, winch and wire rope are properly configured
  Learn more+

• What are the key points for safe operation of automatic punching machine?

  2020-03-01
  Since the appearance of full-automatic punching machines with good reputation, it has brought great convenience to the NC processing industry. Therefore, full-automatic punching machines with moderate prices occupy a crucial position in the NC processing industry, prompting more processing industries to buy such equipment. In order to ensure better operation
  Learn more+

• What do you know about the application range of automatic punching machine?

  2019-12-11
  The punching speed of the punch of the punching machine is 2.5 times that of similar products, which improves the punching force. The installation position of the viewfinder is fixed and the camera is direct, which overcomes the data changes caused by the movement of the viewfinder, improves the positioning accuracy of the workpiece, and greatly improves the reliability of data acquisition and workpiece positioning
  Learn more+

• What are the debugging methods of the automatic punching machine?

  2019-10-11
  During commissioning, it is not necessary to feed materials, but it is necessary to first raise the guide screw on the guide plate, and then gradually adjust the ram of the punch to the bottom dead center by inching. It is necessary to pay special attention to that the guide plate should not press the floating rod too low, otherwise the floating rod will be bent or broken& n
  Learn more+

• What is the difference between automatic pipe punching machine and drilling machine?

  2019-10-11
  Comparison between punching machine and pipe punching machine 1: drilling is the process of drilling holes on processing materials with a drill bit, while the pipe punching machine is the process of punching holes under the drill bit by gravity. The automatic pipe punching machine is suitable for processing soft materials, because the holes drilled by the drilling machine will have burrs and unevenness. Drilling machine is suitable for adding
  Learn more+

• The punching machine factory teaches you how to maintain the pipe automatic punching machine!

  2019-10-11
  In order to give better play to the performance of the pipe punching machine, what matters should be paid attention to when the pipe punching machine is used and later maintenance. The oil of the pipe punching machine needs to be replaced regularly. Basically, it needs to be replaced every year, and the time should be less than three months, that is, three months
  Learn more+