Drilling is the process of drilling holes on the processing materials with a drill bit, while the pipe punching machine is the process of punching holes under the drill bit by gravity. Automatic pipe punching machine is suitable for processing soft materials, Guangxi Semi automatic hydraulic punching machine Because the holes drilled by the drilling machine will have burrs and unevenness. The drilling machine is suitable for processing hard materials, because the punching force of the pipe punching machine often causes cracks in the processing materials. Semi automatic hydraulic punching machine manufactor The processing objects of punching machine and pipe punching machine are similar to a large extent. The punching machine is divided into ordinary punching machine, rapid punching machine, etc. Since the punching machine needs a feeding system, its volume is generally large. The automatic pipe punching machine is a further development of the punch, which solves the problem that the punch needs an independent feeding system, so it is small in size.

During commissioning, it is not necessary to feed materials, but it is necessary to first raise the guide screw on the guide plate, and then gradually adjust the ram of the punch to the bottom dead center by inching. It is necessary to pay special attention to that the guide plate should not press the floating rod too low, otherwise the floating rod will be bent or broken. major Semi automatic hydraulic punching machine manufactor When starting the punching machine for continuous punching, it is necessary to rotate the speed adjusting screw of the nc servo feeder clockwise. The slider moves slightly slowly, so that it can be seen whether the slider touches the nylon gasket and the length adjusting screw when it moves back and forth. Semi automatic hydraulic punching machine If the full-automatic punching machine only touches the length adjusting screw but not the nylon gasket when the sliding block moves back and forth, it is because the floating rod is lowered too deep, and the guide screw on the punching machine needs to be gradually raised.

Use the numerical control zinc steel fence punching machine. The equipment is accurate and fast, with excellent product effect, simple and convenient operation and long service life, Guangxi major Semi automatic hydraulic punching machine It is the best choice for pipe punching. However, no matter how good the machine is, it also needs to pay attention to daily maintenance in order to make it perform to a large extent. The working fluid shall be replaced once a year, and the replacement time shall not exceed three months. Semi automatic hydraulic punching machine manufactor The sliding block shall be filled with lubricating oil frequently, the exposed surface of the column shall be kept clean frequently, and oil shall be sprayed before each work. If the machine is out of service for a long time, the surface should be cleaned and coated with antirust oil. The pressure gauge shall be calibrated and checked every six months.

The hydraulic high-speed punching machine is widely used for punching stainless steel (aluminum alloy) profiles, fan factories, air conditioning accessory factories, antenna factories and other hardware. Automatic and semi-automatic equipment can be customized. Guangxi Semi automatic hydraulic punching machine Anti theft net punching equipment, anti-theft window punching, protective window punching machine, anti-theft net equipment factory stainless steel anti-theft net hydraulic punching machine is your choice! The anti-theft net punching machine has a positioning rod with a scale, which is convenient for direct reading, accurate positioning, flat punching, etc, major Semi automatic hydraulic punching machine It can adjust the perforation and single face at will. It is an ideal punching equipment for anti-theft net, guardrail and shelf