First, observe the safety operation regulations of the numerical control punching machine. When the punching equipment is in place, the chassis should be leveled and stabilized. The punching frame should be vertical, and grounding protection should be done according to the construction power requirements. secondly, Guangzhou CNC punching machine Which one is good Before starting work, carefully check whether each component is properly configured and whether the fastening part is loose. If there is any abnormality, timely and correctly handle it. Numerically controlled punching machines are usually equipped with a variety of protective devices, CNC punching machine Before starting operation, make sure that these protective devices can work normally, which can improve the safety protection performance of the NC punching machine during operation and effectively reduce the accident rate during operation. In addition, the operator shall wear all kinds of armor as required, clean up the sundries on the machine table and within a certain range around, and irrelevant personnel shall not be close to the working area when the punching machine is running.

Drilling is the process of drilling holes on the processing materials with a drill bit, while the pipe punching machine is the process of punching holes under the drill bit by gravity. Automatic pipe punching machine is suitable for processing soft materials, Guangzhou CNC punching machine Because the holes drilled by the drilling machine will have burrs and unevenness. The drilling machine is suitable for processing hard materials, because the punching force of the pipe punching machine often causes cracks in the processing materials. CNC punching machine Which one is good The processing objects of punching machine and pipe punching machine are similar to a large extent. The punching machine is divided into ordinary punching machine, rapid punching machine, etc. Since the punching machine needs a feeding system, its volume is generally large. The automatic pipe punching machine is a further development of the punch, which solves the problem that the punch needs an independent feeding system, so it is small in size.

When the parts of the pipe punching machine are working, under the rated working conditions, they will not be damaged in any form, nor will they produce residual deformation beyond the allowable limit, and can ensure the normal operation and work of the machine, so it is considered that the parts meet the strength requirements. Guangzhou CNC punching machine In design, most important parts are checked by strength conditions (relevant strength theory in engineering mechanics), except some parts with small force or complex shape that cannot be calculated are determined by experience and experiments. major CNC punching machine If the strength of the parts is not enough, the overall fracture, surface contact fatigue or plastic deformation and other failures will occur and the working ability will be lost, so the strength requirements must be met when designing the parts.

Pay attention to the operating condition of the equipment when starting the square pipe punching machine, Guangzhou CNC punching machine In case of abnormal noise and displacement, the square tube punching machine shall be shut down in time, and fault diagnosis and maintenance shall be carried out. Since the clamping and separating action of the pneumatic part of the professional square pipe punching machine requires high flexibility, major CNC punching machine When in use, not only should the pneumatic part be checked regularly to see whether it can be sucked and pulled freely, but also should pay attention to whether there is air leakage in the square tube punching machine.