Don't just look at the price, but consider the manufacturing process of CNC punching machines from the perspective of quality and cycle, which can be roughly divided into ten categories. The climbing frame punching machine is based on different requirements of part materials, physical and chemical properties, mechanical strength, dimensional accuracy, surface finish, service life, economy, etc, Chengdu Guardrail CNC punching machine Select different types of dies to form. Some parts have special requirements when forming, and the CNC punching machine also needs to use advanced processes such as hot runner, gas assisted molding, cylinder, etc. major Guardrail CNC punching machine In general, whether the machine tool has a blank holder mechanism, or even a side lubricant, multi station progressive, etc., should be considered for large stamping dies. The climbing frame punching machine should not only focus on product design, but also ignore the service life of the mold.

In order to ensure the flexibility of the pipe punching machine, Chengdu Guardrail CNC punching machine Which one is good The sliding block also needs to be often injected with lubricating oil. Generally, before the pipe punching machine runs, it needs to be injected with oil. The column surface of the pipe punching machine also needs to be clean. If the pipe punching machine has not been used for a long time Chengdu Guardrail CNC punching machine The surface shall be cleaned and coated with antirust oil to avoid corrosion and rust. The pipe punching machine should also be checked regularly, and the pressure gauge should be checked once every 6 months.

In order to give better play to the performance of the pipe punching machine, what matters should be paid attention to when the pipe punching machine is used and when it is maintained later? The oil of the pipe punching machine needs to be replaced regularly, basically every year, Chengdu major Guardrail CNC punching machine It should take less than three months, that is to say, it needs to be replaced within three months. Check whether there is any problem with the protective safety device, lubrication and other parts, and whether the relevant fastening screws are firm and loose. Guardrail CNC punching machine Which one is good When the mechanical operation is over, cut off the power supply and wipe the machine tool. In short, special attention should be paid to the daily use of the pipe punching machine, and regular inspection and maintenance should be carried out to ensure that the pipe punching machine can operate efficiently and normally.

The lubrication function of the pipe punching machine will be gradually weakened after long-term use, which will lead to increased friction and damage in the process of equipment operation. Even professional pipe punching machines are not immune, Chengdu Guardrail CNC punching machine Therefore, in order to avoid this kind of situation, it is necessary to add lubricant in time, especially the position of the punch to maintain lubrication, reduce friction and extend the service life of the equipment. The pipe punching machine is the most taboo to be impacted by foreign objects. Even if the impact degree is not large, component failure is likely to occur. Guardrail CNC punching machine Which one is good Therefore, whether before or after use, check whether there is any foreign matter between the punch and the lower die, and use carefully to prevent the punch from being damaged due to the extrusion of the punch and the lower die caused by foreign matters.