When debugging the pointer friction force of the numerical control punching machine, first place the pointer at the zero point, and then place it at the test position, purchase Punching machine Then let the pendulum swing by releasing the button, which means that the pointer should not exceed the zero point. If it exceeds the zero point, it is necessary to inject lubricating oil into the pointer bearing or release the spring pressure of the pointer to debug it. The purpose of debugging the professional CNC punching machine is to ensure that the punching machine can have better punching quality and precision, so we carefully debug the punching machine that has just been purchased or replaced with more important parts, Punching machine manufactor In this way, the ideal punching effect can be obtained. At the same time, accurate debugging is also an effective protection for the service life of the NC punching machine itself.

Pipe automatic punching machine processing enterprises have been looking for a more suitable punching equipment with various functions. The high-quality Jinhai Mechanical CNC punching machine can automatically switch the working mode of double-sided hole and single-sided hole punching, Hunan purchase Punching machine At the same time, it can also realize punching processing of pipes, angle iron flat iron, channel steel groove aluminum and other profiles on the same machine, Punching machine This has also saved a lot of equipment costs for enterprises and greatly increased the efficiency of production and processing to a certain extent.

First, observe the safety operation regulations of the numerical control punching machine. When the punching equipment is in place, the chassis should be leveled and stabilized. The punching frame should be vertical, and grounding protection should be done according to the construction power requirements. secondly, Hunan Punching machine manufactor Before starting work, carefully check whether each component is properly configured and whether the fastening part is loose. If there is any abnormality, timely and correctly handle it. Numerically controlled punching machines are usually equipped with a variety of protective devices, Punching machine Before starting operation, make sure that these protective devices can work normally, which can improve the safety protection performance of the NC punching machine during operation and effectively reduce the accident rate during operation. In addition, the operator shall wear all kinds of armor as required, clean up the sundries on the machine table and within a certain range around, and irrelevant personnel shall not be close to the working area when the punching machine is running.

For CNC punching machine equipment, quality is the hard truth for enterprises to survive. Therefore, we must ensure the stability of product quality. Equipment and materials of CNC punching machine; Due to the increased cost of current materials, Hunan Punching machine manufactor Some enterprises will start with raw materials and choose inferior materials to replace them. The result is that the product quality is not guaranteed. Before using the automatic CNC punching machine, be sure to check whether there are sundries at the punch and the lower die edge. Add lubricating oil to the upper and lower moving parts of the punch. Punching machine During use, keep the oiling part of the numerical control punching machine free of oil shortage. At the same time, it should be noted that after the use of the NC punching machine is completed, the NC punching machine should be cleaned first, and the punch should be pressed down to the low position to better protect the NC punching machine.

Once the pipe rack punching machine contacts the water source, it is easy for the machine to break down, so the enterprise should ensure that the equipment can stay away from the water source and maintain a dry environment. If the water ingress at the solenoid valve is more serious, Hunan purchase Punching machine Parts may rust and cannot be used normally. Besides, the humid substances in the air will also damage the system elements, so it is necessary to ensure that the compressed air of the equipment is always dry. Only in this way can we effectively avoid machine failures and increase maintenance costs, and give full play to the advantages of high accuracy and efficiency of equipment. When using the pipe punching machine, the enterprise should also let the staff carefully check the equipment parts exposed to the air. Punching machine Once any abnormality is found, the operation should be stopped, and the operation should be restarted after troubleshooting. This can effectively protect the equipment from damage and extend its life to provide quality services for enterprises.