The main function of the piercing head of the numerical control punching machine is to punch the position where stainless steel and other materials need to be punched, so its position must be adjusted accurately. When debugging, pay attention to, Hainan major Semi automatic hydraulic punching machine In the measuring range, when the center of the pendulum is at a low point, the tip of the piercing head should be at the horizontal position of the rotation axis of the pendulum. Remove the sample splint with heavy weight, adjust the pointer to the place with large value, then place the numerical control punching machine at the position where the test starts and press the release button to let the pendulum swing, Semi automatic hydraulic punching machine Under normal circumstances, the pointer should be at the zero point. If not, use the zero adjustment screw to adjust. If it is necessary to replace heavy lumps with different weights during use, the zero point shall be re adjusted.

During commissioning, it is not necessary to feed materials, but it is necessary to first raise the guide screw on the guide plate, and then gradually adjust the ram of the punch to the bottom dead center by inching. It is necessary to pay special attention to that the guide plate should not press the floating rod too low, otherwise the floating rod will be bent or broken. major Semi automatic hydraulic punching machine manufactor When starting the punching machine for continuous punching, it is necessary to rotate the speed adjusting screw of the nc servo feeder clockwise. The slider moves slightly slowly, so that it can be seen whether the slider touches the nylon gasket and the length adjusting screw when it moves back and forth. Semi automatic hydraulic punching machine If the full-automatic punching machine only touches the length adjusting screw but not the nylon gasket when the sliding block moves back and forth, it is because the floating rod is lowered too deep, and the guide screw on the punching machine needs to be gradually raised.

The stamping part adopts hydraulic oil cylinder, which uses oil as the working medium to transmit movement through the change of sealing volume, Hainan major Semi automatic hydraulic punching machine Power is transmitted through the pressure inside the oil. Digital control punch to achieve the feeding function, climbing frame automatic punching machine manufacturers, computers installed with specific programs to control the system automatic machine tools. The control system can process compiled codes with conditioning and logic, and then realize the machining of parts. Semi automatic hydraulic punching machine The CNC punch feeder adopts two groups of simultaneous feeding and conveying, which avoids the disadvantage of material slippage in the process of conveying materials at high speed and long distance, and avoids stretching of the conveyed materials, as well as the effect of automatic correction of materials.

We often consider what numerical control mechanical equipment is the ideal of the mechanical industry. major Semi automatic hydraulic punching machine High degree of automation control; The NC punching machine with high degree of automation has become a good helper for pipe processing enterprises. Employees only need to master some key data, Hainan Semi automatic hydraulic punching machine manufactor And these devices are usually simple to operate, fast and efficient. CNC punching machine has high cost performance ratio; At present, there are few enterprises that can really reach this standard, because some enterprises in the NC punching machine industry only care about the price, and do not care about product quality and after-sales.