First, observe the safety operation regulations of the numerical control punching machine. When the punching equipment is in place, the chassis should be leveled and stabilized. The punching frame should be vertical, and grounding protection should be done according to the construction power requirements. secondly, Hangzhou Zinc steel guardrail punching machine manufactor Before starting work, carefully check whether each component is properly configured and whether the fastening part is loose. If there is any abnormality, timely and correctly handle it. Numerically controlled punching machines are usually equipped with a variety of protective devices, Zinc steel guardrail punching machine Before starting operation, make sure that these protective devices can work normally, which can improve the safety protection performance of the NC punching machine during operation and effectively reduce the accident rate during operation. In addition, the operator shall wear all kinds of armor as required, clean up the sundries on the machine table and within a certain range around, and irrelevant personnel shall not be close to the working area when the punching machine is running.

The insufficient strength of the punching machine for zinc steel guardrail is the direct cause of the fracture or excessive residual deformation of the parts in work. Hangzhou Zinc steel guardrail punching machine manufactor The strength of parts is divided into volume strength and surface contact strength. For example, if the stress produced by the pipe punching machine parts under the load is within a large volume, the strength of the parts under this stress state is called volume strength (strength for short). Zinc steel guardrail punching machine If two parts change from point contact or line contact to small surface contact before and after being loaded, and their surfaces produce large local stress (called contact stress), then the strength of the parts is called surface contact strength (called contact strength for short).

We know that the punching machine will vibrate during operation, which is common sense, but for the friction phenomenon caused by the loosening of the mold and the lower steel plate, Hangzhou Zinc steel guardrail punching machine manufactor Many people do not pay enough attention to it. Some of them will use steel plates to pad under the mold when the abrasive tool is loose, but this cannot solve the fundamental problem and needs to be paid enough attention. purchase Zinc steel guardrail punching machine When purchasing a CNC punching machine, you must pay attention to carefully check some details, and have more knowledge of the CNC punching machine, so that it will be more convenient to purchase. In addition, it is recommended that you choose some manufacturers with high brand, so that the product quality can be more guaranteed, and more worries can be solved.

The stamping part adopts hydraulic oil cylinder, which uses oil as the working medium to transmit movement through the change of sealing volume, Hangzhou purchase Zinc steel guardrail punching machine Power is transmitted through the pressure inside the oil. Digital control punch to achieve the feeding function, climbing frame automatic punching machine manufacturers, computers installed with specific programs to control the system automatic machine tools. The control system can process compiled codes with conditioning and logic, and then realize the machining of parts. Zinc steel guardrail punching machine The CNC punch feeder adopts two groups of simultaneous feeding and conveying, which avoids the disadvantage of material slippage in the process of conveying materials at high speed and long distance, and avoids stretching of the conveyed materials, as well as the effect of automatic correction of materials.

If the round pipe punching machine used by the enterprise has the specified special hydraulic oil, the special hydraulic oil should be used according to the requirements instead of mixing with other types of hydraulic oil. Hangzhou purchase Zinc steel guardrail punching machine If the round pipe punching machine does not have the specified hydraulic oil, the appropriate hydraulic oil brand can be selected according to the working environment and working conditions of the hydraulic system. After selecting the type of hydraulic oil, the enterprise must also determine the viscosity of the hydraulic oil required by the pipe punching machine. Zinc steel guardrail punching machine The viscosity should be selected according to the temperature range of the geographical location. Generally speaking, the thinner hydraulic oil can be used in the northern region, and the hydraulic oil with a slightly higher viscosity can be used in the southern region. Because the temperature in the north is low, if the viscosity of the hydraulic oil is high, it is not conducive to the operation of the hydraulic system in the low temperature environment.