In the past, the traditional punching machine usually used manual or semi-automatic punching to finish punching the workpiece. Now, with the continuous progress of punching machine technology, some shortcomings of the former manual punching machine itself are more and more obvious, Dalian Hydraulic punching machine manufactor The speed is very slow, so the efficiency is very low. If it is semi-automatic, automatic feeding cannot be carried out. CNC climbing frame punching machine needs frequent maintenance to ensure its life; Before operation, check whether the punch and die of the numerical control punching machine are matched, otherwise the punching machine host will be damaged. When assembling the upper and lower moulds, the models of the upper and lower moulds must be the same, and the fixing sleeve of the upper mould must be tightened. purchase Hydraulic punching machine When placing the lower die, pay attention to the upward direction of the knife edge (the end with a small aperture), and do not damage the machine by installing it. Do not remove the quick coupler when the system has working pressure during operation. The screw rod and nut shall be lubricated with oil.

The stamping part adopts hydraulic oil cylinder, which uses oil as the working medium to transmit movement through the change of sealing volume, Dalian purchase Hydraulic punching machine Power is transmitted through the pressure inside the oil. Digital control punch to achieve the feeding function, climbing frame automatic punching machine manufacturers, computers installed with specific programs to control the system automatic machine tools. The control system can process compiled codes with conditioning and logic, and then realize the machining of parts. Hydraulic punching machine The CNC punch feeder adopts two groups of simultaneous feeding and conveying, which avoids the disadvantage of material slippage in the process of conveying materials at high speed and long distance, and avoids stretching of the conveyed materials, as well as the effect of automatic correction of materials.

The insufficient strength of the punching machine for zinc steel guardrail is the direct cause of the fracture or excessive residual deformation of the parts in work. Dalian Hydraulic punching machine manufactor The strength of parts is divided into volume strength and surface contact strength. For example, if the stress produced by the pipe punching machine parts under the load is within a large volume, the strength of the parts under this stress state is called volume strength (strength for short). Hydraulic punching machine If two parts change from point contact or line contact to small surface contact before and after being loaded, and their surfaces produce large local stress (called contact stress), then the strength of the parts is called surface contact strength (called contact strength for short).

This model is equipped with two punching cylinders, which can be used for punching single or multiple cylinders respectively. The upper cylinder can be adjusted to punch half or full holes. The climbing frame automatic punching machine is easy to operate, superior in quality and reasonable in price, Dalian Hydraulic punching machine It meets the quality requirements of domestic and foreign markets, and can process high-quality and high-precision workpieces. The punching hole of this machine is flat without burrs, and the positioning is accurate. The clamping, lifting and other mechanisms of the whole machine are controlled by air pressure or hydraulic pressure. The positioning of workpieces (X, Y coordinates) is driven by servo, and the control of the whole machine is controlled by microcomputer, Hydraulic punching machine manufactor Parameter setting and operation switching are performed through the touch screen interface, which is simple and convenient to operate, and can store more than 100 product processing parameters.

With the continuous development of China's manufacturing industry, the technical level of punching machines and other equipment is required to be higher and higher. The requirements of the market for equipment determine that punching machine manufacturers should constantly improve the technical level of their products. Rack punching machine manufacturers should follow the market development and produce high-end punching equipment, Dalian purchase Hydraulic punching machine With the help of the intelligent trend of the development of China's machine tool industry, the punching machine technology is brought to a higher level. In addition, Hydraulic punching machine When punching, after the mold is installed, insert the pipe for punching. It is strictly prohibited to empty punch when there is no pipe, otherwise the mold will be damaged. When punching the full hole, if there is no punching, it will automatically return. Please move the lower proximity switch downward to protect the mold.