The main function of the piercing head of the numerical control punching machine is to punch the position where stainless steel and other materials need to be punched, so its position must be adjusted accurately. When debugging, pay attention to, Harbin purchase Numerical control punching machine for zinc steel guardrail In the measuring range, when the center of the pendulum is at a low point, the tip of the piercing head should be at the horizontal position of the rotation axis of the pendulum. Remove the sample splint with heavy weight, adjust the pointer to the place with large value, then place the numerical control punching machine at the position where the test starts and press the release button to let the pendulum swing, Numerical control punching machine for zinc steel guardrail Under normal circumstances, the pointer should be at the zero point. If not, use the zero adjustment screw to adjust. If it is necessary to replace heavy lumps with different weights during use, the zero point shall be re adjusted.

Most of the current shelves, fences, guardrails and anti-theft nets are processed by CNC punching machines, Harbin Numerical control punching machine for zinc steel guardrail It is very fast in speed and high in accuracy. There is no burr. The hole surface has a good finish. Now using the CNC punching machine will make it easier to clamp the workpiece, purchase Numerical control punching machine for zinc steel guardrail It is also unnecessary to use some special fixtures during processing, which can effectively reduce the cost of fixtures, avoid multiple clamping, and effectively improve the product process.

First, observe the safety operation regulations of the numerical control punching machine. When the punching equipment is in place, the chassis should be leveled and stabilized. The punching frame should be vertical, and grounding protection should be done according to the construction power requirements. secondly, Harbin Numerical control punching machine for zinc steel guardrail Which one is good Before starting work, carefully check whether each component is properly configured and whether the fastening part is loose. If there is any abnormality, timely and correctly handle it. Numerically controlled punching machines are usually equipped with a variety of protective devices, Numerical control punching machine for zinc steel guardrail Before starting operation, make sure that these protective devices can work normally, which can improve the safety protection performance of the NC punching machine during operation and effectively reduce the accident rate during operation. In addition, the operator shall wear all kinds of armor as required, clean up the sundries on the machine table and within a certain range around, and irrelevant personnel shall not be close to the working area when the punching machine is running.

In order to give better play to the performance of the pipe punching machine, what matters should be paid attention to when the pipe punching machine is used and when it is maintained later? The oil of the pipe punching machine needs to be replaced regularly, basically every year, Harbin purchase Numerical control punching machine for zinc steel guardrail It should take less than three months, that is to say, it needs to be replaced within three months. Check whether there is any problem with the protective safety device, lubrication and other parts, and whether the relevant fastening screws are firm and loose. Numerical control punching machine for zinc steel guardrail Which one is good When the mechanical operation is over, cut off the power supply and wipe the machine tool. In short, special attention should be paid to the daily use of the pipe punching machine, and regular inspection and maintenance should be carried out to ensure that the pipe punching machine can operate efficiently and normally.

In order to enable the square pipe punching machine to effectively achieve a sound punching effect, the punching of the equipment should be checked regularly, purchase Numerical control punching machine for zinc steel guardrail And ensure that there is no aging in the mold to prevent the punching effect of processed objects from being affected. In order to make the square pipe punching machine have a better punching effect and extend its service life, Numerical control punching machine for zinc steel guardrail Which one is good During the use, adequate maintenance and overhaul shall be carried out, and the greasy dirt and other dirt on the equipment shall be cleaned timely after each punching operation.