The lubrication function of the pipe punching machine will be gradually weakened after long-term use, which will lead to increased friction and damage in the process of equipment operation. Even professional pipe punching machines are not immune, Tianjin Auto punching machine Therefore, in order to avoid this kind of situation, it is necessary to add lubricant in time, especially the position of the punch to maintain lubrication, reduce friction and extend the service life of the equipment. The pipe punching machine is the most taboo to be impacted by foreign objects. Even if the impact degree is not large, component failure is likely to occur. Auto punching machine Which one is good Therefore, whether before or after use, check whether there is any foreign matter between the punch and the lower die, and use carefully to prevent the punch from being damaged due to the extrusion of the punch and the lower die caused by foreign matters.

Don't just look at the price, but consider the manufacturing process of CNC punching machines from the perspective of quality and cycle, which can be roughly divided into ten categories. The climbing frame punching machine is based on different requirements of part materials, physical and chemical properties, mechanical strength, dimensional accuracy, surface finish, service life, economy, etc, Tianjin Auto punching machine Select different types of dies to form. Some parts have special requirements when forming, and the CNC punching machine also needs to use advanced processes such as hot runner, gas assisted molding, cylinder, etc. purchase Auto punching machine In general, whether the machine tool has a blank holder mechanism, or even a side lubricant, multi station progressive, etc., should be considered for large stamping dies. The climbing frame punching machine should not only focus on product design, but also ignore the service life of the mold.

During the test run of the full-automatic punching machine, the sliding block moves back and forth. If the stainless steel pipe fence punching machine only touches the nylon gasket and does not touch the length adjustment screw, it is because the floating rod can not be lowered deep, and the guide screw on the punching machine needs to be gradually adjusted downward. purchase Auto punching machine Which one is good The hydraulic high-speed punching machine is widely used in stainless steel (zinc steel, aluminum alloy, steel pipe, welded pipe, seamless pipe, square pipe, round pipe, flat iron, channel steel, angle iron) profiles, fan factories, air conditioning parts factories, antenna factories, shelf factories, metal furniture factories, automobile parts factories Tianjin Auto punching machine Building materials manufacturers and other hardware pipe fittings, profiles punching processing. Automatic and semi-automatic equipment can be customized according to customer requirements.

In order to improve the safety of operation, the operators should not only strictly abide by their posts, but also place all tools and accessories on the NC punching machine at the specified positions, so as to avoid accidents caused by the impact on the equipment during the operation of the punching machine. If everyone can follow the regulations when operating the NC punching machine, and do a good job in the relevant inspection work, and at the same time improve the safety awareness, then the operation safety of the NC punching machine can be effectively improved, which can not only make employees feel safer when working, but also improve the efficiency of production and processing, And save the cost of handling accidents for enterprises.

During commissioning, it is not necessary to feed materials, but it is necessary to first raise the guide screw on the guide plate, and then gradually adjust the ram of the punch to the bottom dead center by inching. It is necessary to pay special attention to that the guide plate should not press the floating rod too low, otherwise the floating rod will be bent or broken. purchase Auto punching machine Which one is good When starting the punching machine for continuous punching, it is necessary to rotate the speed adjusting screw of the nc servo feeder clockwise. The slider moves slightly slowly, so that it can be seen whether the slider touches the nylon gasket and the length adjusting screw when it moves back and forth. Auto punching machine If the full-automatic punching machine only touches the length adjusting screw but not the nylon gasket when the sliding block moves back and forth, it is because the floating rod is lowered too deep, and the guide screw on the punching machine needs to be gradually raised.