In the past, the traditional punching machine usually used manual or semi-automatic punching to finish punching the workpiece. Now, with the continuous progress of punching machine technology, some shortcomings of the former manual punching machine itself are more and more obvious, Changchun Semi automatic hydraulic punching machine Price The speed is very slow, so the efficiency is very low. If it is semi-automatic, automatic feeding cannot be carried out. CNC climbing frame punching machine needs frequent maintenance to ensure its life; Before operation, check whether the punch and die of the numerical control punching machine are matched, otherwise the punching machine host will be damaged. When assembling the upper and lower moulds, the models of the upper and lower moulds must be the same, and the fixing sleeve of the upper mould must be tightened. major Semi automatic hydraulic punching machine When placing the lower die, pay attention to the upward direction of the knife edge (the end with a small aperture), and do not damage the machine by installing it. Do not remove the quick coupler when the system has working pressure during operation. The screw rod and nut shall be lubricated with oil.

The main function of the piercing head of the numerical control punching machine is to punch the position where stainless steel and other materials need to be punched, so its position must be adjusted accurately. When debugging, pay attention to, Changchun major Semi automatic hydraulic punching machine In the measuring range, when the center of the pendulum is at a low point, the tip of the piercing head should be at the horizontal position of the rotation axis of the pendulum. Remove the sample splint with heavy weight, adjust the pointer to the place with large value, then place the numerical control punching machine at the position where the test starts and press the release button to let the pendulum swing, Semi automatic hydraulic punching machine Under normal circumstances, the pointer should be at the zero point. If not, use the zero adjustment screw to adjust. If it is necessary to replace heavy lumps with different weights during use, the zero point shall be re adjusted.

Pay attention to the operating condition of the equipment when starting the square pipe punching machine, Changchun Semi automatic hydraulic punching machine In case of abnormal noise and displacement, the square tube punching machine shall be shut down in time, and fault diagnosis and maintenance shall be carried out. Since the clamping and separating action of the pneumatic part of the professional square pipe punching machine requires high flexibility, major Semi automatic hydraulic punching machine When in use, not only should the pneumatic part be checked regularly to see whether it can be sucked and pulled freely, but also should pay attention to whether there is air leakage in the square tube punching machine.

In order to ensure the flexibility of the pipe punching machine, Changchun Semi automatic hydraulic punching machine Price The sliding block also needs to be often injected with lubricating oil. Generally, before the pipe punching machine runs, it needs to be injected with oil. The column surface of the pipe punching machine also needs to be clean. If the pipe punching machine has not been used for a long time Changchun Semi automatic hydraulic punching machine The surface shall be cleaned and coated with antirust oil to avoid corrosion and rust. The pipe punching machine should also be checked regularly, and the pressure gauge should be checked once every 6 months.