First, observe the safety operation regulations of the numerical control punching machine. When the punching equipment is in place, the chassis should be leveled and stabilized. The punching frame should be vertical, and grounding protection should be done according to the construction power requirements. secondly, Shenzhen Stainless steel punching machine manufactor Before starting work, carefully check whether each component is properly configured and whether the fastening part is loose. If there is any abnormality, timely and correctly handle it. Numerically controlled punching machines are usually equipped with a variety of protective devices, Stainless steel punching machine Before starting operation, make sure that these protective devices can work normally, which can improve the safety protection performance of the NC punching machine during operation and effectively reduce the accident rate during operation. In addition, the operator shall wear all kinds of armor as required, clean up the sundries on the machine table and within a certain range around, and irrelevant personnel shall not be close to the working area when the punching machine is running.

When debugging the pointer friction force of the numerical control punching machine, first place the pointer at the zero point, and then place it at the test position, purchase Stainless steel punching machine Then let the pendulum swing by releasing the button, which means that the pointer should not exceed the zero point. If it exceeds the zero point, it is necessary to inject lubricating oil into the pointer bearing or release the spring pressure of the pointer to debug it. The purpose of debugging the professional CNC punching machine is to ensure that the punching machine can have better punching quality and precision, so we carefully debug the punching machine that has just been purchased or replaced with more important parts, Stainless steel punching machine manufactor In this way, the ideal punching effect can be obtained. At the same time, accurate debugging is also an effective protection for the service life of the NC punching machine itself.

When punching with the climbing frame punching machine, the die shall be installed and inserted into the pipe for punching. It is strictly prohibited to empty punch when there is no pipe, otherwise the die will be damaged, Shenzhen Stainless steel punching machine When punching full holes, if there is no punching, it will automatically return. Please move the lower proximity switch downward to protect the mold. In addition, it should be noted that the CNC climbing frame punching machine needs inspection and maintenance after running for a period of time. Check whether the blade of the punching needle has been passivated. If it has been passivated, please remove the punching needle and grind it, or purchase a new punching needle from the climbing frame punching machine manufacturer. In winter, the temperature becomes low. To protect the equipment, Stainless steel punching machine manufactor If necessary, the engine should be started up and run idle for a period of time to warm up; If the equipment operates for a long time, check the temperature of the equipment. The temperature of the hydraulic oil should be controlled between 30 and 60 ℃.

In order to improve the safety of operation, the operators should not only strictly abide by their posts, but also place all tools and accessories on the NC punching machine at the specified positions, so as to avoid accidents caused by the impact on the equipment during the operation of the punching machine. If everyone can follow the regulations when operating the NC punching machine, and do a good job in the relevant inspection work, and at the same time improve the safety awareness, then the operation safety of the NC punching machine can be effectively improved, which can not only make employees feel safer when working, but also improve the efficiency of production and processing, And save the cost of handling accidents for enterprises.