When debugging the pointer friction force of the numerical control punching machine, first place the pointer at the zero point, and then place it at the test position, purchase CNC punching machine Then let the pendulum swing by releasing the button, which means that the pointer should not exceed the zero point. If it exceeds the zero point, it is necessary to inject lubricating oil into the pointer bearing or release the spring pressure of the pointer to debug it. The purpose of debugging the professional CNC punching machine is to ensure that the punching machine can have better punching quality and precision, so we carefully debug the punching machine that has just been purchased or replaced with more important parts, CNC punching machine Which one is good In this way, the ideal punching effect can be obtained. At the same time, accurate debugging is also an effective protection for the service life of the NC punching machine itself.

During commissioning, it is not necessary to feed materials, but it is necessary to first raise the guide screw on the guide plate, and then gradually adjust the ram of the punch to the bottom dead center by inching. It is necessary to pay special attention to that the guide plate should not press the floating rod too low, otherwise the floating rod will be bent or broken. purchase CNC punching machine Which one is good When starting the punching machine for continuous punching, it is necessary to rotate the speed adjusting screw of the nc servo feeder clockwise. The slider moves slightly slowly, so that it can be seen whether the slider touches the nylon gasket and the length adjusting screw when it moves back and forth. CNC punching machine If the full-automatic punching machine only touches the length adjusting screw but not the nylon gasket when the sliding block moves back and forth, it is because the floating rod is lowered too deep, and the guide screw on the punching machine needs to be gradually raised.

With the arrival of the automation era, the use of CNC thick wall pipe punching machines has become more and more common. However, in the process of using the punching machine, we should first pay attention to safety production. The site where the stainless steel punching machine is used should remove obstacles such as hole locations and surrounding stones according to the requirements of the punching machine instructions. Dalian CNC punching machine Which one is good The distance from the operation site to the power transformer or power supply trunk line shall be within 200m, and the voltage drop during startup shall not exceed 10% of the rated voltage. The motor and control box shall have good grounding device. Before installation, CNC punching machine Check and confirm that the punch bar and all parts are free of deformation; After installation, the allowable deviation of the center line between the punch and the power head is 1% of the total length.

High efficiency and high precision of products are the main direction. Speed and precision are two important indicators of CNC machine tools such as punching machines, which directly affect the quality and grade of products, the production cycle of products and the competitiveness in the market. Dalian CNC punching machine Which one is good The improvement of machining accuracy requires improving the control accuracy of the system; High efficiency requires improving the parameters of high-end CNC system. secondly, CNC punching machine We should develop in the direction of intelligence. Intelligent punching machines are required to have the characteristics of automation and intelligence. Artificial intelligence is constantly infiltrating and developing in the computer field. Numerical control systems are developing in the direction of intelligence. With the help of intelligent technology, equipment has the functions of adaptive control, intelligent diagnosis, intelligent monitoring, etc.

The customer should implement the configuration of the automatic punching machine, such as working and operating principles, motor power, etc. purchase CNC punching machine Which one is good It also depends on what is easy to ignore at ordinary times: such as the thickness of steel plate, or even the material of die steel. Whether the machine table is reinforced or thickened. CNC punching machine See if the design is humanized. Mechanical things will inevitably break down, but some businesses only consider occupying the market at a low price without considering these details, but these details will directly affect the customer's future production.