In order to ensure that the round pipe punching machine has good quality and use effect, it is recommended that enterprises choose genuine hydraulic oil with relatively high cost performance. Because the hydraulic oil with good brand has high purity and less impurities, it will not be worn by impurities after being used for the round pipe punching machine, and the oil is not easy to deteriorate, Shijiazhuang Numerical control punching machine for zinc steel guardrail Can play a better role. As the hydraulic system is an important part of the pipe punching machine, and the hydraulic oil plays a crucial role in it, purchase Numerical control punching machine for zinc steel guardrail When using the round pipe punching machine, enterprises should not only use the equipment according to the operating rules, but also pay attention to adding and replacing the hydraulic oil in the hydraulic system regularly to ensure that the quality and life of the round pipe punching machine will not be affected.

First, observe the safety operation regulations of the numerical control punching machine. When the punching equipment is in place, the chassis should be leveled and stabilized. The punching frame should be vertical, and grounding protection should be done according to the construction power requirements. secondly, Shijiazhuang Numerical control punching machine for zinc steel guardrail manufactor Before starting work, carefully check whether each component is properly configured and whether the fastening part is loose. If there is any abnormality, timely and correctly handle it. Numerically controlled punching machines are usually equipped with a variety of protective devices, Numerical control punching machine for zinc steel guardrail Before starting operation, make sure that these protective devices can work normally, which can improve the safety protection performance of the NC punching machine during operation and effectively reduce the accident rate during operation. In addition, the operator shall wear all kinds of armor as required, clean up the sundries on the machine table and within a certain range around, and irrelevant personnel shall not be close to the working area when the punching machine is running.

When debugging the pointer friction force of the numerical control punching machine, first place the pointer at the zero point, and then place it at the test position, purchase Numerical control punching machine for zinc steel guardrail Then let the pendulum swing by releasing the button, which means that the pointer should not exceed the zero point. If it exceeds the zero point, it is necessary to inject lubricating oil into the pointer bearing or release the spring pressure of the pointer to debug it. The purpose of debugging the professional CNC punching machine is to ensure that the punching machine can have better punching quality and precision, so we carefully debug the punching machine that has just been purchased or replaced with more important parts, Numerical control punching machine for zinc steel guardrail manufactor In this way, the ideal punching effect can be obtained. At the same time, accurate debugging is also an effective protection for the service life of the NC punching machine itself.

The main function of the piercing head of the numerical control punching machine is to punch the position where stainless steel and other materials need to be punched, so its position must be adjusted accurately. When debugging, pay attention to, Shijiazhuang purchase Numerical control punching machine for zinc steel guardrail In the measuring range, when the center of the pendulum is at a low point, the tip of the piercing head should be at the horizontal position of the rotation axis of the pendulum. Remove the sample splint with heavy weight, adjust the pointer to the place with large value, then place the numerical control punching machine at the position where the test starts and press the release button to let the pendulum swing, Numerical control punching machine for zinc steel guardrail Under normal circumstances, the pointer should be at the zero point. If not, use the zero adjustment screw to adjust. If it is necessary to replace heavy lumps with different weights during use, the zero point shall be re adjusted.