With the arrival of the automation era, the use of CNC thick wall pipe punching machines has become more and more common. However, in the process of using the punching machine, we should first pay attention to safety production. The site where the stainless steel punching machine is used should remove obstacles such as hole locations and surrounding stones according to the requirements of the punching machine instructions. Chengdu Full automatic punching machine Which one is good The distance from the operation site to the power transformer or power supply trunk line shall be within 200m, and the voltage drop during startup shall not exceed 10% of the rated voltage. The motor and control box shall have good grounding device. Before installation, Full automatic punching machine Check and confirm that the punch bar and all parts are free of deformation; After installation, the allowable deviation of the center line between the punch and the power head is 1% of the total length.

During the test run of the full-automatic punching machine, the sliding block moves back and forth. If the stainless steel pipe fence punching machine only touches the nylon gasket and does not touch the length adjustment screw, it is because the floating rod can not be lowered deep, and the guide screw on the punching machine needs to be gradually adjusted downward. major Full automatic punching machine Which one is good The hydraulic high-speed punching machine is widely used in stainless steel (zinc steel, aluminum alloy, steel pipe, welded pipe, seamless pipe, square pipe, round pipe, flat iron, channel steel, angle iron) profiles, fan factories, air conditioning parts factories, antenna factories, shelf factories, metal furniture factories, automobile parts factories Chengdu Full automatic punching machine Building materials manufacturers and other hardware pipe fittings, profiles punching processing. Automatic and semi-automatic equipment can be customized according to customer requirements.

We know that the punching machine will vibrate during operation, which is common sense, but for the friction phenomenon caused by the loosening of the mold and the lower steel plate, Chengdu Full automatic punching machine Which one is good Many people do not pay enough attention to it. Some of them will use steel plates to pad under the mold when the abrasive tool is loose, but this cannot solve the fundamental problem and needs to be paid enough attention. major Full automatic punching machine When purchasing a CNC punching machine, you must pay attention to carefully check some details, and have more knowledge of the CNC punching machine, so that it will be more convenient to purchase. In addition, it is recommended that you choose some manufacturers with high brand, so that the product quality can be more guaranteed, and more worries can be solved.

During commissioning, it is not necessary to feed materials, but it is necessary to first raise the guide screw on the guide plate, and then gradually adjust the ram of the punch to the bottom dead center by inching. It is necessary to pay special attention to that the guide plate should not press the floating rod too low, otherwise the floating rod will be bent or broken. major Full automatic punching machine Which one is good When starting the punching machine for continuous punching, it is necessary to rotate the speed adjusting screw of the nc servo feeder clockwise. The slider moves slightly slowly, so that it can be seen whether the slider touches the nylon gasket and the length adjusting screw when it moves back and forth. Full automatic punching machine If the full-automatic punching machine only touches the length adjusting screw but not the nylon gasket when the sliding block moves back and forth, it is because the floating rod is lowered too deep, and the guide screw on the punching machine needs to be gradually raised.