The insufficient strength of the punching machine for zinc steel guardrail is the direct cause of the fracture or excessive residual deformation of the parts in work. Nanning Full automatic punching machine manufactor The strength of parts is divided into volume strength and surface contact strength. For example, if the stress produced by the pipe punching machine parts under the load is within a large volume, the strength of the parts under this stress state is called volume strength (strength for short). Full automatic punching machine If two parts change from point contact or line contact to small surface contact before and after being loaded, and their surfaces produce large local stress (called contact stress), then the strength of the parts is called surface contact strength (called contact strength for short).

For CNC punching machine equipment, quality is the hard truth for enterprises to survive. Therefore, we must ensure the stability of product quality. Equipment and materials of CNC punching machine; Due to the increased cost of current materials, Nanning Full automatic punching machine manufactor Some enterprises will start with raw materials and choose inferior materials to replace them. The result is that the product quality is not guaranteed. Before using the automatic CNC punching machine, be sure to check whether there are sundries at the punch and the lower die edge. Add lubricating oil to the upper and lower moving parts of the punch. Full automatic punching machine During use, keep the oiling part of the numerical control punching machine free of oil shortage. At the same time, it should be noted that after the use of the NC punching machine is completed, the NC punching machine should be cleaned first, and the punch should be pressed down to the low position to better protect the NC punching machine.

Pipe automatic punching machine processing enterprises have been looking for a more suitable punching equipment with various functions. The high-quality Jinhai Mechanical CNC punching machine can automatically switch the working mode of double-sided hole and single-sided hole punching, Nanning major Full automatic punching machine At the same time, it can also realize punching processing of pipes, angle iron flat iron, channel steel groove aluminum and other profiles on the same machine, Full automatic punching machine This has also saved a lot of equipment costs for enterprises and greatly increased the efficiency of production and processing to a certain extent.

The main function of the piercing head of the numerical control punching machine is to punch the position where stainless steel and other materials need to be punched, so its position must be adjusted accurately. When debugging, pay attention to, Nanning major Full automatic punching machine In the measuring range, when the center of the pendulum is at a low point, the tip of the piercing head should be at the horizontal position of the rotation axis of the pendulum. Remove the sample splint with heavy weight, adjust the pointer to the place with large value, then place the numerical control punching machine at the position where the test starts and press the release button to let the pendulum swing, Full automatic punching machine Under normal circumstances, the pointer should be at the zero point. If not, use the zero adjustment screw to adjust. If it is necessary to replace heavy lumps with different weights during use, the zero point shall be re adjusted.

This model is equipped with two punching cylinders, which can be used for punching single or multiple cylinders respectively. The upper cylinder can be adjusted to punch half or full holes. The climbing frame automatic punching machine is easy to operate, superior in quality and reasonable in price, Nanning Full automatic punching machine It meets the quality requirements of domestic and foreign markets, and can process high-quality and high-precision workpieces. The punching hole of this machine is flat without burrs, and the positioning is accurate. The clamping, lifting and other mechanisms of the whole machine are controlled by air pressure or hydraulic pressure. The positioning of workpieces (X, Y coordinates) is driven by servo, and the control of the whole machine is controlled by microcomputer, Full automatic punching machine manufactor Parameter setting and operation switching are performed through the touch screen interface, which is simple and convenient to operate, and can store more than 100 product processing parameters.