In order to improve the safety of operation, the operators should not only strictly abide by their posts, but also place all tools and accessories on the NC punching machine at the specified positions, so as to avoid accidents caused by the impact on the equipment during the operation of the punching machine. If everyone can follow the regulations when operating the NC punching machine, and do a good job in the relevant inspection work, and at the same time improve the safety awareness, then the operation safety of the NC punching machine can be effectively improved, which can not only make employees feel safer when working, but also improve the efficiency of production and processing, And save the cost of handling accidents for enterprises.

Once the pipe rack punching machine contacts the water source, it is easy for the machine to break down, so the enterprise should ensure that the equipment can stay away from the water source and maintain a dry environment. If the water ingress at the solenoid valve is more serious, Hangzhou major Stainless steel punching machine Parts may rust and cannot be used normally. Besides, the moist substances in the air will also damage the system elements, so it is necessary to ensure that the compressed air of the equipment is always dry. Only in this way can we effectively avoid machine failures and increase maintenance costs, and give full play to the advantages of high accuracy and efficiency of equipment. When using the pipe punching machine, the enterprise should also let the staff carefully check the equipment parts exposed to the air. Stainless steel punching machine Once any abnormality is found, the operation should be stopped, and the operation should be restarted after troubleshooting. This can effectively protect the equipment from damage and extend its life to provide quality services for enterprises.

During commissioning, it is not necessary to feed materials, but it is necessary to first raise the guide screw on the guide plate, and then gradually adjust the ram of the punch to the bottom dead center by inching. It is necessary to pay special attention to that the guide plate should not press the floating rod too low, otherwise the floating rod will be bent or broken. major Stainless steel punching machine Price When starting the punching machine for continuous punching, it is necessary to rotate the speed adjusting screw of the nc servo feeder clockwise. The slider moves slightly slowly, so that it can be seen whether the slider touches the nylon gasket and the length adjusting screw when it moves back and forth. Stainless steel punching machine If the full-automatic punching machine only touches the length adjusting screw but not the nylon gasket when the sliding block moves back and forth, it is because the floating rod is lowered too deep, and the guide screw on the punching machine needs to be gradually raised.

With the continuous development of China's manufacturing industry, the technical level of punching machines and other equipment is required to be higher and higher. The requirements of the market for equipment determine that punching machine manufacturers should constantly improve the technical level of their products. Rack punching machine manufacturers should follow the market development and produce high-end punching equipment, Hangzhou major Stainless steel punching machine With the help of the intelligent trend of the development of China's machine tool industry, the punching machine technology is brought to a higher level. In addition, Stainless steel punching machine When punching, after the mold is installed, insert the pipe for punching. It is strictly prohibited to empty punch when there is no pipe, otherwise the mold will be damaged. When punching the full hole, if there is no punching, it will automatically return. Please move the lower proximity switch downward to protect the mold.