With the continuous development of China's manufacturing industry, the technical level of punching machines and other equipment is required to be higher and higher. The requirements of the market for equipment determine that punching machine manufacturers should constantly improve the technical level of their products. Rack punching machine manufacturers should follow the market development and produce high-end punching equipment, Wuhan major Semi automatic hydraulic punching machine With the help of the intelligent trend of the development of China's machine tool industry, the punching machine technology is brought to a higher level. In addition, Semi automatic hydraulic punching machine When punching, after the mold is installed, insert the pipe for punching. It is strictly prohibited to empty punch when there is no pipe, otherwise the mold will be damaged. When punching the full hole, if there is no punching, it will automatically return. Please move the lower proximity switch downward to protect the mold.

In order to ensure the flexibility of the pipe punching machine, Wuhan Semi automatic hydraulic punching machine Price The sliding block also needs to be often injected with lubricating oil. Generally, before the pipe punching machine runs, it needs to be injected with oil. The column surface of the pipe punching machine also needs to be clean. If the pipe punching machine has not been used for a long time Wuhan Semi automatic hydraulic punching machine The surface shall be cleaned and coated with antirust oil to avoid corrosion and rust. The pipe punching machine should also be checked regularly, and the pressure gauge should be checked once every 6 months.

In the past, the traditional punching machine usually used manual or semi-automatic punching to finish punching the workpiece. Now, with the continuous progress of punching machine technology, some shortcomings of the former manual punching machine itself are more and more obvious, Wuhan Semi automatic hydraulic punching machine Price The speed is very slow, so the efficiency is very low. If it is semi-automatic, automatic feeding cannot be carried out. CNC climbing frame punching machine needs frequent maintenance to ensure its life; Before operation, check whether the punch and die of the numerical control punching machine are matched, otherwise the punching machine host will be damaged. When assembling the upper and lower moulds, the models of the upper and lower moulds must be the same, and the fixing sleeve of the upper mould must be tightened. major Semi automatic hydraulic punching machine When placing the lower die, pay attention to the upward direction of the knife edge (the end with a small aperture), and do not damage the machine by installing it. Do not remove the quick coupler when the system has working pressure during operation. The screw rod and nut shall be lubricated with oil.

In order to give better play to the performance of the pipe punching machine, what matters should be paid attention to when the pipe punching machine is used and when it is maintained later? The oil of the pipe punching machine needs to be replaced regularly, basically every year, Wuhan major Semi automatic hydraulic punching machine It should take less than three months, that is to say, it needs to be replaced within three months. Check whether there is any problem with the protective safety device, lubrication and other parts, and whether the relevant fastening screws are firm and loose. Semi automatic hydraulic punching machine Price When the mechanical operation is over, cut off the power supply and wipe the machine tool. In short, special attention should be paid to the daily use of the pipe punching machine, and regular inspection and maintenance should be carried out to ensure that the pipe punching machine can operate efficiently and normally.