In order to give better play to the performance of the pipe punching machine, what matters should be paid attention to when the pipe punching machine is used and when it is maintained later? The oil of the pipe punching machine needs to be replaced regularly, basically every year, Taiyuan major Rack CNC punching machine It should take less than three months, that is to say, it needs to be replaced within three months. Check whether there is any problem with the protective safety device, lubrication and other parts, and whether the relevant fastening screws are firm and loose. Rack CNC punching machine Which one is good When the mechanical operation is over, cut off the power supply and wipe the machine tool. In short, special attention should be paid to the daily use of the pipe punching machine, and regular inspection and maintenance should be carried out to ensure that the pipe punching machine can operate efficiently and normally.

The automatic punching machine has beautiful appearance, reasonable and simple structure, and is easy to operate, Taiyuan Rack CNC punching machine Which one is good In this way, the cost of training staff can be saved, and the accuracy of the automatic punching machine is high. The climbing frame automatic punching machine agent is not easy to make mistakes, major Rack CNC punching machine Even the most rigorous operation can be completed accurately. The operation screen of the automatic punching machine is a 7-inch touch screen, which is convenient for operation. The automatic punching machine adopts hydraulic and mechanical structure, with stable physical performance and strong adaptability.

In order to enable the square pipe punching machine to effectively achieve a sound punching effect, the punching of the equipment should be checked regularly, major Rack CNC punching machine And ensure that there is no aging in the mold to prevent the punching effect of processed objects from being affected. In order to make the square pipe punching machine have a better punching effect and extend its service life, Rack CNC punching machine Which one is good During the use, adequate maintenance and overhaul shall be carried out, and the greasy dirt and other dirt on the equipment shall be cleaned timely after each punching operation.

In the past, the traditional punching machine usually used manual or semi-automatic punching to finish punching the workpiece. Now, with the continuous progress of punching machine technology, some shortcomings of the former manual punching machine itself are more and more obvious, Taiyuan Rack CNC punching machine Which one is good The speed is very slow, so the efficiency is very low. If it is semi-automatic, automatic feeding cannot be carried out. CNC climbing frame punching machine needs frequent maintenance to ensure its life; Before operation, check whether the punch and die of the numerical control punching machine are matched, otherwise the punching machine host will be damaged. When assembling the upper and lower moulds, the models of the upper and lower moulds must be the same, and the fixing sleeve of the upper mould must be tightened. major Rack CNC punching machine When placing the lower die, pay attention to the upward direction of the knife edge (the end with a small aperture), and do not damage the machine by installing it. Do not remove the quick coupler when the system has working pressure during operation. The screw rod and nut shall be lubricated with oil.