For CNC punching machine equipment, quality is the hard truth for enterprises to survive. Therefore, we must ensure the stability of product quality. Equipment and materials of CNC punching machine; Due to the increased cost of current materials, Hunan Rack CNC punching machine Which one is good Some enterprises will start with raw materials and choose inferior materials to replace them. The result is that the product quality is not guaranteed. Before using the automatic CNC punching machine, be sure to check whether there are sundries at the punch and the lower die edge. Add lubricating oil to the upper and lower moving parts of the punch. Rack CNC punching machine During use, keep the oiling part of the numerical control punching machine free of oil shortage. At the same time, it should be noted that after the use of the NC punching machine is completed, the NC punching machine should be cleaned first, and the punch should be pressed down to the low position to better protect the NC punching machine.

The normal CNC punching machine can customize the operation procedure of the product according to the customer's product requirements, Hunan Rack CNC punching machine And the whole process does not require professional computer personnel to program. The CNC punching machine has specially designed a humanized human-computer interactive operation screen. The operator only needs to input the required punching hole diameter, punching hole position, thickness and other variables, and then just wait and observe whether the equipment is in good condition. The CNC punching machine adopts the domestic double vane pump as the main component equipment of its bearings, major Rack CNC punching machine Compared with the traditional pump, this equipment has the characteristics of low noise, high efficiency, large flow and long service life. At the same time, the high-quality CNC punching machine is specially equipped with a high-quality cooling system to ensure the smooth and efficient operation of the equipment.

Pay attention to the operating condition of the equipment when starting the square pipe punching machine, Hunan Rack CNC punching machine In case of abnormal noise and displacement, the square tube punching machine shall be shut down in time, and fault diagnosis and maintenance shall be carried out. Since the clamping and separating action of the pneumatic part of the professional square pipe punching machine requires high flexibility, major Rack CNC punching machine When in use, not only should the pneumatic part be checked regularly to see whether it can be sucked and pulled freely, but also should pay attention to whether there is air leakage in the square tube punching machine.

In order to give better play to the performance of the pipe punching machine, what matters should be paid attention to when the pipe punching machine is used and when it is maintained later? The oil of the pipe punching machine needs to be replaced regularly, basically every year, Hunan major Rack CNC punching machine It should take less than three months, that is to say, it needs to be replaced within three months. Check whether there is any problem with the protective safety device, lubrication and other parts, and whether the relevant fastening screws are firm and loose. Rack CNC punching machine Which one is good When the mechanical operation is over, cut off the power supply and wipe the machine tool. In short, special attention should be paid to the daily use of the pipe punching machine, and regular inspection and maintenance should be carried out to ensure that the pipe punching machine can operate efficiently and normally.

We know that the punching machine will vibrate during operation, which is common sense, but for the friction phenomenon caused by the loosening of the mold and the lower steel plate, Hunan Rack CNC punching machine Which one is good Many people do not pay enough attention to it. Some of them will use steel plates to pad under the mold when the abrasive tool is loose, but this cannot solve the fundamental problem and needs to be paid enough attention. major Rack CNC punching machine When purchasing a CNC punching machine, you must pay attention to carefully check some details, and have more knowledge of the CNC punching machine, so that it will be more convenient to purchase. In addition, it is recommended that you choose some manufacturers with high brand, so that the product quality can be more guaranteed, and more worries can be solved.