With the arrival of the automation era, the use of CNC thick wall pipe punching machines has become more and more common. However, in the process of using the punching machine, we should first pay attention to safety production. The site where the stainless steel punching machine is used should remove obstacles such as hole locations and surrounding stones according to the requirements of the punching machine instructions. Shanxi Climbing frame CNC punching machine manufactor The distance from the operation site to the power transformer or power supply trunk line shall be within 200m, and the voltage drop during startup shall not exceed 10% of the rated voltage. The motor and control box shall have good grounding device. Before installation, Climbing frame CNC punching machine Check and confirm that the punch bar and all parts are free of deformation; After installation, the allowable deviation of the center line between the punch and the power head is 1% of the total length.

In order to ensure that the round pipe punching machine has good quality and use effect, it is recommended that enterprises choose genuine hydraulic oil with relatively high cost performance. Because the hydraulic oil with good brand has high purity and less impurities, it will not be worn by impurities after being used for the round pipe punching machine, and the oil is not easy to deteriorate, Shanxi Climbing frame CNC punching machine Can play a better role. As the hydraulic system is an important part of the pipe punching machine, and the hydraulic oil plays a crucial role in it, purchase Climbing frame CNC punching machine When using the round pipe punching machine, enterprises should not only use the equipment according to the operating rules, but also pay attention to adding and replacing the hydraulic oil in the hydraulic system regularly to ensure that the quality and life of the round pipe punching machine will not be affected.

During commissioning, it is not necessary to feed materials, but it is necessary to first raise the guide screw on the guide plate, and then gradually adjust the ram of the punch to the bottom dead center by inching. It is necessary to pay special attention to that the guide plate should not press the floating rod too low, otherwise the floating rod will be bent or broken. purchase Climbing frame CNC punching machine manufactor When starting the punching machine for continuous punching, it is necessary to rotate the speed adjusting screw of the nc servo feeder clockwise. The slider moves slightly slowly, so that it can be seen whether the slider touches the nylon gasket and the length adjusting screw when it moves back and forth. Climbing frame CNC punching machine If the full-automatic punching machine only touches the length adjusting screw but not the nylon gasket when the sliding block moves back and forth, it is because the floating rod is lowered too deep, and the guide screw on the punching machine needs to be gradually raised.

When punching with the climbing frame punching machine, after the mold is installed, insert the pipe for punching. It is strictly prohibited to empty punch when there is no pipe, otherwise the mold will be damaged, Shanxi Climbing frame CNC punching machine When punching full holes, if there is no punching, it will automatically return. Please move the lower proximity switch downward to protect the mold. In addition, it should be noted that the CNC climbing frame punching machine needs inspection and maintenance after running for a period of time. Check whether the blade of the punching needle has been passivated. If it has been passivated, please remove the punching needle and grind it, or purchase a new punching needle from the climbing frame punching machine manufacturer. In winter, the temperature becomes low. To protect the equipment, Climbing frame CNC punching machine manufactor If necessary, the engine should be started up and run idle for a period of time to warm up; If the equipment operates for a long time, check the temperature of the equipment. The temperature of the hydraulic oil should be controlled between 30 and 60 ℃.