During commissioning, it is not necessary to feed materials, but it is necessary to first raise the guide screw on the guide plate, and then gradually adjust the ram of the punch to the bottom dead center by inching. It is necessary to pay special attention to that the guide plate should not press the floating rod too low, otherwise the floating rod will be bent or broken. major Climbing frame punching machine Price When starting the punching machine for continuous punching, it is necessary to rotate the speed adjusting screw of the nc servo feeder clockwise. The slider moves slightly slowly, so that it can be seen whether the slider touches the nylon gasket and the length adjusting screw when it moves back and forth. Climbing frame punching machine If the full-automatic punching machine only touches the length adjusting screw but not the nylon gasket when the sliding block moves back and forth, it is because the floating rod is lowered too deep, and the guide screw on the punching machine needs to be gradually raised.

In order to ensure the flexibility of the pipe punching machine, Henan Climbing frame punching machine Price The sliding block also needs to be often injected with lubricating oil. Generally, before the pipe punching machine runs, it needs to be injected with oil. The column surface of the pipe punching machine also needs to be clean. If the pipe punching machine has not been used for a long time Henan Climbing frame punching machine The surface shall be cleaned and coated with antirust oil to avoid corrosion and rust. The pipe punching machine should also be checked regularly, and the pressure gauge should be checked once every 6 months.

Once the high-end CNC punching machine breaks down, its working efficiency will be seriously affected. If it is improperly operated, it will also have a more fatal impact on the life of the equipment. major Climbing frame punching machine Price Using the rack punching machine in strict accordance with the standard can not only improve the efficiency, but also extend the service life. Determine whether your equipment is multi station or single station, and talk about the multi station punching machine, Henan Climbing frame punching machine When in use, only one oil circuit switch can be opened for operation at a time, and multiple oil circuit switches cannot be opened at the same time. Many people will use multiple switches simultaneously to improve efficiency, which will have a bad impact on equipment operation and processing quality.

During the test run of the full-automatic punching machine, the sliding block moves back and forth. If the stainless steel pipe fence punching machine only touches the nylon gasket and does not touch the length adjustment screw, it is because the floating rod can not be lowered deep, and the guide screw on the punching machine needs to be gradually adjusted downward. major Climbing frame punching machine Price The hydraulic high-speed punching machine is widely used in stainless steel (zinc steel, aluminum alloy, steel pipe, welded pipe, seamless pipe, square pipe, round pipe, flat iron, channel steel, angle iron) profiles, fan factories, air conditioning parts factories, antenna factories, shelf factories, metal furniture factories, automobile parts factories Henan Climbing frame punching machine Building materials manufacturers and other hardware pipe fittings, profiles punching processing. Automatic and semi-automatic equipment can be customized according to customer requirements.