Once the NC climbing frame punching machine breaks down, its working efficiency will be seriously affected. If it is operated improperly, it will also have a more fatal impact on the life of the equipment. Anhui Climbing frame CNC punching machine manufactor Using NC punching machine strictly according to standards can not only improve efficiency, but also extend service life. Determine whether your equipment is multi station or single station. Let's talk about the multi station CNC punching machine, Climbing frame CNC punching machine When in use, only one oil circuit switch can be opened for operation at a time, and multiple oil circuit switches cannot be opened at the same time. Many people will use multiple switches simultaneously to improve efficiency, which will have a bad impact on equipment operation and processing quality.

The climbing frame punching machine is mainly used for punching operations in industrial processing and manufacturing. Because different processing materials need to be punched in the industrial processing and manufacturing fields and in the building materials industry, Anhui Climbing frame CNC punching machine manufactor Choosing a high-quality square tube punching machine can effectively improve the overall processing efficiency in the processing field. People should pay attention to the regular maintenance and cleaning of the square tube punching machine when using it. Since there are more or less oil stains and sundries left on the surface of the machine after each use, Climbing frame CNC punching machine In order to better maintain the normal operation of the equipment, it is not only necessary to clean the equipment every day for oil stains and sundries, but also to regularly overhaul the key parts of the equipment with abnormal looseness at intervals.

In order to give better play to the performance of the pipe punching machine, what matters should be paid attention to when the pipe punching machine is used and when it is maintained later? The oil of the pipe punching machine needs to be replaced regularly, basically every year, Anhui purchase Climbing frame CNC punching machine It should take less than three months, that is to say, it needs to be replaced within three months. Check whether there is any problem with the protective safety device, lubrication and other parts, and whether the relevant fastening screws are firm and loose. Climbing frame CNC punching machine manufactor When the mechanical operation is over, cut off the power supply and wipe the machine tool. In short, special attention should be paid to the daily use of the pipe punching machine, and regular inspection and maintenance should be carried out to ensure that the pipe punching machine can operate efficiently and normally.

First, observe the safety operation regulations of the numerical control punching machine. When the punching equipment is in place, the chassis should be leveled and stabilized. The punching frame should be vertical, and grounding protection should be done according to the construction power requirements. secondly, Anhui Climbing frame CNC punching machine manufactor Before starting work, carefully check whether each component is properly configured and whether the fastening part is loose. If there is any abnormality, timely and correctly handle it. Numerically controlled punching machines are usually equipped with a variety of protective devices, Climbing frame CNC punching machine Before starting operation, make sure that these protective devices can work normally, which can improve the safety protection performance of the NC punching machine during operation and effectively reduce the accident rate during operation. In addition, the operator shall wear all kinds of armor as required, clean up the sundries on the machine table and within a certain range around, and irrelevant personnel shall not be close to the working area when the punching machine is running.