The insufficient strength of the punching machine for zinc steel guardrail is the direct cause of the fracture or excessive residual deformation of the parts in work. Haikou Semi automatic punching machine Price The strength of parts is divided into volume strength and surface contact strength. For example, if the stress produced by the pipe punching machine parts under the load is within a large volume, the strength of the parts under this stress state is called volume strength (strength for short). Semi automatic punching machine If two parts change from point contact or line contact to small surface contact before and after being loaded, and their surfaces produce large local stress (called contact stress), then the strength of the parts is called surface contact strength (called contact strength for short).

When debugging the pointer friction force of the numerical control punching machine, first place the pointer at the zero point, and then place it at the test position, purchase Semi automatic punching machine Then let the pendulum swing by releasing the button, which means that the pointer should not exceed the zero point. If it exceeds the zero point, it is necessary to inject lubricating oil into the pointer bearing or release the spring pressure of the pointer to debug it. The purpose of debugging the professional CNC punching machine is to ensure that the punching machine can have better punching quality and precision, so we carefully debug the punching machine that has just been purchased or replaced with more important parts, Semi automatic punching machine Price In this way, the ideal punching effect can be obtained. At the same time, accurate debugging is also an effective protection for the service life of the NC punching machine itself.

Once the pipe rack punching machine contacts the water source, it is easy for the machine to break down, so the enterprise should ensure that the equipment can stay away from the water source and maintain a dry environment. If the water ingress at the solenoid valve is more serious, Haikou purchase Semi automatic punching machine Parts may rust and cannot be used normally. Besides, the humid substances in the air will also damage the system elements, so it is necessary to ensure that the compressed air of the equipment is always dry. Only in this way can we effectively avoid machine failures and increase maintenance costs, and give full play to the advantages of high accuracy and efficiency of equipment. When using the pipe punching machine, the enterprise should also let the staff carefully check the equipment parts exposed to the air. Semi automatic punching machine Once any abnormality is found, the operation should be stopped, and the operation should be restarted after troubleshooting. This can effectively protect the equipment from damage and extend its life to provide quality services for enterprises.

The ordinary pipe punching machine has no automatic positioning system, which is equivalent to a small punching machine that solves the feeding problem. Automatic pipe punching machine adds automatic positioning system on the basis of ordinary pipe punching machine, Haikou Semi automatic punching machine Price It greatly improves the precision and speed of punching, which can be understood as an automatic controlled high-precision small punch. The automatic pipe punching machine can not only position itself, but also automatically feed materials in batches, greatly saving manpower. The hydraulic automatic pipe punching machine produced by our factory adopts large torque AC synchronous servo motor, Semi automatic punching machine It is characterized by fast response, high positioning accuracy, low noise, small brake heat loss and long service life. Motion control: professional PLC controller, touch screen operation, simple and convenient.