Climbing frame punching machine It is one of the indispensable and important equipment in processing enterprises, especially in the stainless steel pipe industry. Although the climbing frame is easy to use Punching machine High safety and simple operation, but we still need to pay attention to the standard operating principles in order to reduce the occurrence of unexpected failures.

The following is the use of the collection for you Stainless steel punching machine Safety principle of

1、 Overall commissioning and inspection of equipment before operation

1. Checking the equipment before using the climbing frame punching machine for punching is a "homework" that must be done to ensure that the equipment can meet the safety requirements in the production process.

2. Mainly check whether each line is normal and whether the ground wire is properly connected. All installed molds and fixing bolts should be tightened with screws,

3. Before operation, a simple test run shall be carried out to adjust the running speed of the equipment,

4. The speed needs to be adjusted according to the needs of actual processing and the degree to which the operation can adapt.

2、 Use safety protection device during operation

1. When formally operating the climbing frame punching machine, pay attention to the proper use of protective equipment, such as wearing protective clothing or protective gloves to avoid safety accidents caused by splashing steel pipe debris during rapid processing.

2. In addition, when working with gloves, be careful not to check whether there is a long thread end, so as to prevent the high-speed stainless steel punching machine from drawing the glove thread end into the equipment and causing human injury.

3. Moreover, do not place such items as lines or ropes on the operating table.

4. In addition, it should be noted that in case of "strike" of the equipment during operation, the operator cannot disassemble or repair the equipment without permission, so as to avoid personal injury caused by improper operation and further equipment failure.

3、 The disassembly shall be standardized after operation

1. After using the climbing frame punching machine, pay attention to all the finishing work. After all, after a long time of work, the machine is surrounded by debris. You need to take a comprehensive "bath" to ensure a better working state when operating the equipment next time.

2. In this step, you must pay attention to the specifications.

3. It is necessary to turn off the power first and then carry out the operation when the equipment is shut down, and wait until the die head cools down before carrying out the specific operation. The die head just completed will burn hands when it is in a very high temperature.

4. When removing the mold and clamping tools, be careful not to use a hammer or knock with hard objects, and try to wear canvas gloves to operate so as not to hurt the sharp mold head.

It can be seen from the above related introduction that:

The climbing frame punching machine needs to pay attention to the principle of safe operation in different stages of operation, so as to ensure high safety in the whole equipment operation with fewer major failures.

At the same time, different enterprises can also restrict the operators by these three safety principles to meet the safety requirements in different stages of operation.

Of course, the premise is to purchase high-performance climbing frame punching machine, so as to ensure that the quality of the details of the equipment is excellent without problems and improve safety productivity.