1、 Prevention Rack punching machine Several measures for stamping deformation:

1. Punch every other hole first, and then return to the remaining holes.

Although this will also produce stress, it will alleviate the stress accumulation during the sequential stamping in the same direction, and also make the stress of the front and rear two groups of holes offset each other, thus preventing the deformation of the sheet metal.

2. Try to avoid making too narrow strips.

When punching the sheet with width less than the thickness of the sheet with the NC turret punching die, the punch will bend and deform due to the lateral force, making the clearance on one side too small or increasing wear. In serious cases, the lower mold will be scratched and the upper and lower molds will be damaged.

3. Shelf Punching machine Do not step on narrow strips whose width is less than 2.5 times of the plate thickness.

When the strip is cut too narrow, the sheet will tend to bend into the opening of the lower die, rather than being completely cut, or even wedged into the side of the die. If the above situation cannot be avoided, please use the return plate, which is a fully guided die used to support the punch of the CNC turret punch.

In modern enterprises, more and more industries need to use shelf punching machines. Its excellent performance can create greater benefits for enterprises and reduce costs for enterprises.

2、 So how can we prevent minor errors when the device has poor performance?

1. We can start from small details and pay attention to maintenance at ordinary times.

For example, read the operation manual carefully before daily operation to understand the performance of the operating equipment and what are the restrictions on operation;

It is necessary to check the lubrication degree of the parts, add lubricating oil if necessary, and clean the residue in time during operation to avoid affecting the operation of the equipment;

If there is a fault during operation, it must be handled first before starting operation;

2. Another important detail in application is polishing.

This detail is often ignored. If the polishing is not smooth enough, it is easy to have faults in the operation process, and even cause other faults in serious cases Stainless steel punching machine We must do a good job in polishing, so as to prevent problems before they happen.

3. All Automatic rack punching machine The original reason was to replace manual grinding and drilling, so as to improve the production efficiency of the factory.

new generation Full automatic CNC punching machine Put into use, try to use special detail design during manufacturing, which can save a lot of time for mold replacement.

The rack punching machine not only improves the working efficiency of die changing, but also improves the material input process, which also improves the working efficiency of the punching machine.

4. Full automatic CNC punching machine combines high technology in the process of design and post production.

The purpose is to make the production noise of the punching machine lower than that of the manual machine, so as to avoid the pollution of the noise to the surrounding environment.

In addition, the power consumption of the rack punching machine has been greatly improved. Through the transformation of the internal circuit of the machine, the power consumption has been greatly reduced, and the purpose of environmental protection and energy saving has been achieved.