Rack punching machine It is a machine used for punching the shelves.

During the use, some problems may occur due to various reasons and need to be corrected.

The following are some common corrections that must be made.

1. Adjust the upper and lower positions of punching tools.

The up and down adjustment of the punching tool is one of the key steps of punching processing, and the tool needs to be adjusted to the appropriate position according to the actual needs.

If the position of the punching tool is incorrect, the error in the punching process will increase, thus affecting the punching quality.

2. Adjust the front and rear position of the punching tool.

The fore and aft adjustment of the punching tool is also a very important step, which affects the accuracy and consistency of the rack punching.

If the position of the punching tool is incorrect, it may lead to inaccurate punching position, or even misplacement of punching.

3. Check the wear of the mold.

The mold is a shelf Punching machine The indispensable parts in the may be worn after a long time of use.

If the mold is found to be worn, it needs to be replaced or repaired in time.

Otherwise, the worn die will affect the quality of punching, resulting in inaccurate or incomplete punching hole diameter.

4. Check the cutting edge status of the punching tool.

When punching, the cutting edge of the punching tool is vulnerable to damage due to friction and extrusion with materials.

If there is obvious wear or scratch on the cutting edge of the tool, it is necessary to replace the tool or repair the cutting edge in time.

Otherwise, the worn edge will lead to problems such as increased punching cutting force, inaccurate punching hole diameter, etc.

5. Adjust the processing parameters.

The processing parameters of rack punching machine include punching force, stroke, feed speed, etc.

Corresponding processing parameters need to be adjusted according to different materials, hole diameters and punching shapes.

If the processing parameters are incorrect, the punching quality may be unstable, or even the punching tool may break.

6. Clean and lubricate.

After a long time of use, the rack punching machine may accumulate impurities such as dust, chips and lubricants, which may affect the normal operation of the machine.

Therefore, it is necessary to clean the rack punching machine regularly and give proper lubrication.

Cleaning and lubrication can reduce the wear of the machine, extend the service life, and also help to improve the punching quality.

7. Check the punching process.

Punching process is an important part of standardized management of punching process.

The whole punching process needs to be evaluated and checked to ensure the rationality and feasibility of the process.

If problems are found in the process, it needs to be adjusted and improved in time to improve punching efficiency and quality.

The above is the corrective measures that must be taken for the rack punching machine. In the actual operation process, it is necessary to pay close attention to the working state and punching quality of the punching machine, find problems in time and correct them to ensure the accuracy and stability of punching processing.