Adjust first Rack punching machine To level the fuselage, and then make rough adjustment Punching machine And then adjust the relative position of the reassembled main moving parts and the host machine, such as the adjustment of the tool changing position of the manipulator, tool magazine and the host machine. Start the commissioning and operation status of each component.

The rack punching machine uses precision level, standard square ruler, level ruler, collimator and other measuring tools to fine adjust the moving parts on the main body of the machine body with anchor bolts and sizing blocks on the solidified foundation, such as columns, sliding plates and worktables, observe the horizontal changes of the equipment in the whole process of each coordinate, and adjust the geometric accuracy of the machine within the tolerance range.

During the adjustment, the sizing block is mainly adjusted. If necessary, slightly change the insert strip and pre tightening roller on the guide rail to make the rack punching machine reach the factory precision. Let the rack punching machine automatically move to the tool exchange position, and then manually adjust the position of the tool loading manipulator and the tool unloading manipulator relative to the spindle.

When the rack punching machine is adjusted, a calibration mandrel is generally used for detection. In case of error, fine adjustment can be made by adjusting the travel of the manipulator, moving the manipulator support and the position of the tool magazine. If necessary, the setting of the tool change position point can also be modified. After adjustment, tighten each adjusting screw and the foundation bolt of the tool magazine, and then install several tool handles for repeated reciprocating automatic exchange from the tool magazine to the spindle. It is required that the action shall be accurate, and there shall be no impact and knife drop.