Zinc steel guardrail punching machine It is a very practical machine equipment.

It can be used to process various types of zinc steel guardrails to ensure the safety of roads and parks.

Now let's understand how to assemble and debug zinc steel Guardrail punching machine Right.

1、 Tools to be prepared before assembly include:

1. Wrench:

It is recommended to use two sizes of wrenches: large and medium.

2. Screwdriver:

It is necessary to obtain different types of screws. The screws on some machines are metal surface treated,

It needs to be tightened very carefully to avoid scratching them due to excessive force.

3. Universal wrench:

This is another tool required for installing the machine, which can be used to replace screws or install panel switches during installation.

4. Pneumatic or electric tools:

During installation and later maintenance, the use of pneumatic or electric tools can reduce some laborious manual operations.

2、 The assembly steps are as follows:

1. Zinc steel guardrail Punching machine The components of,

2. For convenience, we can use brackets or equipment racks to fix them on the ground or workbench.

3. Loosen the four screws at the bottom of the machine, remove the bottom plate, and find the adjustable center bottom support foot inside the machine;

4. Close the bottom plate to the two bottom feet inside the machine, and then tighten the bottom feet, so that the machine will not jump.

5. Put the shaft sleeve on the shaft, then fasten the shaft on the bottom plate, tighten the screws at the bottom, and pay attention to the direction of rotation;

6. To install and adjust tools and dies.

7. Install the dies and molds for processing on the machine, and pay attention to the assembly method and positioning between them,

8. Take extra care during installation to avoid damaging them.

9. Install the motor and electric control components of the machine, connect the circuit, and tighten various screws with a universal wrench,

10. Ensure the safety of the circuit, adjust the circuit parameters, and adjust the voltage and frequency to an appropriate degree.

11. After installation and commissioning, start the punching machine for zinc steel guardrail, adjust parameters, send processing signals, and then process the zinc steel guardrail according to the required requirements.

3、 Processing

When using machines to process zinc steel guardrails, follow the production operation procedures and use tools correctly,

Protect equipment, ensure operation safety, and produce zinc steel guardrails that meet quality standards and process requirements.

In short, the assembly and commissioning of the zinc steel fence punching machine requires great care and patience,

Use the correct tools and materials, Check and test carefully to ensure the performance and reliability of the machine,

The zinc steel fence punching machine can be better used and better production results can be obtained only by following the operation specifications.