As an important mechanical equipment, Channel steel punching machine It has played an irreplaceable role in our production and life.

However, after long-term use, they often need to be cleaned to ensure the normal operation and service life of the equipment.

Then, let's introduce the channel steel Punching machine Cleaning method.

1、 Preparation for cleaning channel steel punching machine

Before cleaning the channel steel punching machine, the following preparations should be made:

1. Disconnect power:

Before cleaning, disconnect the power supply of the channel steel punching machine to ensure the safety of cleaning.

2. To remove a part from a device:

Dismantle the detachable parts (such as hole position plate, paint groove, etc.) on the equipment and place them in a clean place for standby.

At the same time, use a wrench or wrench set to slowly remove the fixed objects (such as fixed screws) on the equipment, and place them in a container for future use.

3. Debris removal:

Before cleaning the channel steel punching machine, the sundries around the equipment shall be cleaned to prevent sundries from entering the equipment and affecting the normal use of the equipment.

2、 Steps of cleaning channel steel punching machine

1. Clean the outer surface of the channel steel punching machine

The external surface of the channel steel punching machine needs to be cleaned first.

This step is very simple, just use a clean rag or brush, dip in water, and wipe the surface of the equipment.

If the surface of the equipment is dirty, it can be cleaned with soapy water or detergent.

However, it should be noted that acidic or alkaline solutions should not be used for cleaning to avoid corrosion to the equipment and affecting the service life of the equipment.

2. Clean the inside of the channel steel punching machine

Then the interior of the channel steel punching machine needs to be cleaned.

We need to clean up the paint, dust and other sundries in the equipment, and then use a clean brush or cotton cloth to wipe the interior of the equipment.

For some parts that are difficult to scrub, air gun or suction fan can be used for purging.

3. Clean the electrical components on the channel steel punching machine

We need to clean the electrical components on the channel steel punching machine.

This step needs to be very careful, because the electrical part is sensitive and easy to damage.

We can use a vacuum cleaner or a brush to remove the dust and sundries around the electrical components,

Then use professional detergent (such as detergent, electronic cleaning fluid, etc.) for cleaning.

4. Cleaning the lubrication system on the channel steel punching machine

We need to clean the lubrication system on the channel steel punching machine.

The lubrication system is an important part of the normal operation of the equipment, so the cleaning of the lubrication part must be very careful.

We need to remove the components of the lubrication system, remove the dirt and scale, and lubricate with an oil gun.

At the same time, pay attention to the replacement of oil seal, seal ring and other wearing parts.

5. Clean the cooling system on the channel steel punching machine

We also need to clean the cooling system on the channel steel punching machine.

The cooling system is an important part of the cooling equipment, which is also very important for the long-term operation of the equipment.

We can remove the cooler on the equipment, remove the sundries and oil stains inside, and use professional cleaning fluid for cleaning.

3、 Summary

The above is the cleaning method of the channel steel punching machine. I hope it will be helpful to you.

During the cleaning process, it is necessary to pay attention to the proper amount, reasonable steps, caution, etc. to ensure the normal operation and service life of the equipment.

At the same time, the equipment shall be cleaned and maintained regularly to extend its service life and improve its production efficiency.