Foshan Jinhai CNC Machinery Co., Ltd. specializes in the production of climbing frame automatic punch and ladder automatic punch, Climbing frame punching machine , CNC automatic operation. Punching and punching. Very convenient. Suitable for U-shaped steel, square tube, round tube, flat iron, angle iron. Punching and cutting off!

Reading guide of the manufacturer of the full-automatic square tube climbing punch: because the feeding area of the feeder does not intersect with the processing area of the punch. The feeder uses the non processing time gap of the punch. Complete feeding promotion. Therefore, continuous stamping style can be adopted to achieve efficient production capacity. The NC servo feeder can set the feeding distance freely. The feeding distance and the press SPM and the feeding angle are set to be dry. If there is no immediate feeding, the press and the feeder will be stopped in an emergency. Mine flame-retardant buffer bed buffer bed is mainly used to replace the buffer idler. The buffer bed is composed of buffer strip and support. The high elastic special rubber layer of the buffer strip of Zhongshan full-automatic square tube climbing punch can be enough to absorb the impact of falling materials, greatly shorten the impact of falling materials on the transport belt, and reliably improve the stress at the blanking point. Finally, after the use of the machine is completed, turn off the power supply and close the air compressor mold. Plug a piece of head pipe into the mold to prevent the mold from being damaged by careless use when starting up next time. We often make stainless steel Pipe punching machine Die, with round tube Punching machine There is a round pipe punching die, but each kind of die manufacturing has one thing in common. The manufacturer of full-automatic square pipe climbing frame punching machine is the problem of die clearance. We are familiar with the fact that most of the stainless steel round pipes purchased in the market are non-standard, that is, the outer diameter and wall thickness of the round pipe are different from the actual values. For example, the outer diameter of 38mm pipe may be less than 38mm, and the wall thickness of 1mm may be about 0.85mm. How to handle this situation when designing the stainless steel round pipe punching machine mold? At the beginning, the thinner the wall thickness is, the worse the roundness of the pipe is. It must be properly measured when designing the die.